diff doc/Compiling @ 220:60cc20bfe18f

doc/Compiling: update for the new configs
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 15 Oct 2016 23:02:23 +0000
parents 596d86109e44
children 6c594ce434f8
line wrap: on
line diff
--- a/doc/Compiling	Sat Oct 15 22:41:38 2016 +0000
+++ b/doc/Compiling	Sat Oct 15 23:02:23 2016 +0000
@@ -69,9 +69,8 @@
 pirelli		Pirelli DP-L10
 
 For the available configurations (the second required argument to the configure
-script), look in the configs directory.  As of this writing, the most
-interesting configuration is l1reconst - it was named so because it rebuilds L1
-from the reconstructed source.
+script), look in the configs directory and read the Handset-configs and
+Modem-configs write-ups.
 
 Each configuration is built in its own directory; by default the build directory
 is named build-$TARGET-$CONFIG, i.e., for the example configure.sh line above,
@@ -81,10 +80,11 @@
 
 To actually compile the firmware, cd into the created build directory and run
 make there.  Unfortunately the use of TI's proprietary compiler via Wine makes
-the build very slow - it takes about 42 minutes on my machine.  When it's all
-done, the flashable firmware image will be in fwimage.bin.  This image is to be
-flashed with fc-loadtool at address 0x10000 on the C139 and at address 0 on all
-other targets.
+the build very slow - it takes about 42 minutes on my machine for the l1reconst
+configuration, or almost 90 minutes for hybrid.  When it's all done, the
+flashable firmware image will be in fwimage.bin.  This image is to be flashed
+with fc-loadtool at address 0x10000 on the C139 and at address 0 on all other
+targets.
 
 When building firmware for the Pirelli or for future FreeCalypso hardware that
 will use the same high capacity flash+pSRAM chip, one can build either a