FreeCalypso > hg > fc-magnetite
view doc/Freerunner-Howto @ 624:012028896cfb
FFS dev.c, Leonardo target: Fujitsu MB84VF5F5F4J2 #if 0'ed out
The FFS code we got from TI/Openmoko had a stanza for "Fujitsu MB84VF5F5F4J2
stacked device", using a fake device ID code that would need to be patched
manually into cfgffs.c (suppressing and overriding autodetection) and using
an FFS base address in the nCS2 bank, indicating that this FFS config was
probably meant for the MCP version of Leonardo which allows for 16 MiB flash
with a second bank on nCS2.
We previously had this FFS config stanza conditionalized under
CONFIG_TARGET_LEONARDO because the base address contained therein is invalid
for other targets, but now that we actually have a Leonardo build target in
FC Magnetite, I realize that the better approach is to #if 0 out this stanza
altogether: it is already non-functional because it uses a fake device ID
code, thus it is does not add support for more Leonardo board variants,
instead it is just noise.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Sun, 22 Dec 2019 21:24:29 +0000 |
parents | c9a65db8be4a |
children |
line wrap: on
line source
The latest official firmware for Openmoko Neo1973 and Neo FreeRunner Calypso modems is moko13 as of this writing; moko13 is FreeCalypso Magnetite Hg changeset 286:840113655bbf built for the gtamodem target in the l1reconst configuration. There have been many changes in FC Magnetite since then, but few of them affect the l1reconst config on the gtamodem target in any noticeable way. The few noticeable post-moko13 changes which we do have in our current l1reconst code are not deemed important enough to justify making another formal release for a no-longer-made hardware platform that no longer has any real user community either. However, we also have the new TCS2/TCS3 hybrid config in which the old version of the G23M protocol stack from Openmoko (binary libs only, no source) has been replaced with a newer version from TI's TCS3/LoCosto program, and this new version is full source. This hybrid firmware has now reached the state where it is ready to be exercised by adventurous beta users in real-life usage. The new hybrid fw for the gtamodem target can be built as follows: ./configure.sh gtamodem hybrid cd build-gtamodem-hybrid; make Then after enduring the very slow build, you can flash it with fc-loadtool: loadtool> flash erase 0 0x250000 loadtool> flash program-bin 0 fwimage.bin If you are brave enough to do the above, please let us know how this new modem firmware fares when driven by QtMoko or SHR on the AP - it would definitely be an adventure! We would be most interested in working with developers or maintainers of specific AP software components that are directly responsible for talking AT commands to the modem, if there are any such developers or maintainers still around.