FFS dev.c, Leonardo target: Fujitsu MB84VF5F5F4J2 #if 0'ed out The FFS code we got from TI/Openmoko had a stanza for "Fujitsu MB84VF5F5F4J2 stacked device", using a fake device ID code that would need to be patched manually into cfgffs.c (suppressing and overriding autodetection) and using an FFS base address in the nCS2 bank, indicating that this FFS config was probably meant for the MCP version of Leonardo which allows for 16 MiB flash with a second bank on nCS2. We previously had this FFS config stanza conditionalized under CONFIG_TARGET_LEONARDO because the base address contained therein is invalid for other targets, but now that we actually have a Leonardo build target in FC Magnetite, I realize that the better approach is to #if 0 out this stanza altogether: it is already non-functional because it uses a fake device ID code, thus it is does not add support for more Leonardo board variants, instead it is just noise.

[board.cfg]

BOARD 41
DSAMPLE_FULL_COLOR var

[chipset.cfg]

ANLG_FAM 2
ANLG_PG 0
CHIPSET var

[debug.cfg]

TI_NUC_MONITOR 0
TI_PROFILER 0

[dio.cfg]

DIOIL_CONFIG 0

[ffs.cfg]

TARGET 1
_RVF 1

[l1sw.cfg]

AMR var
CUST 0
DCO_ALGO 0
IDS var
L1_12NEIGH 1
L1_EOTD 0
L1_EOTD_QBIT_ACC 0
L1_GPRS var
L1_GTT 0
L1_MIDI 0
L1_VOICE_MEMO_AMR var
MELODY_E2 var
OP_L1_STANDALONE 0
OP_RIV_AUDIO 1
ORDER2_TX_TEMP_CAL 1
RAZ_VULSWITCH_REGAUDIO 0
SECURITY 0
SPEECH_RECO var
TESTMODE 1
TRACE_TYPE 4
VCXO_ALGO 1

[r2d.cfg]

R2D_ASM 0
R2D_LCD_TEST 0

[rf.cfg]

RF var
RF_FAM var
RF_PA var
RF_PG var

[rv.cfg]

RVTOOL 0
TEST 0
_GSM 1

[swconfig.cfg]

ALR 1
BT 0
DP 0
DWNLD 1
GSMLITE 0
L1_DYN_DSP_DWNLD var
LONG_JUMP 3
MOVE_IN_INTERNAL_RAM 1
OP_WCP 0
PMODE var
RVDATA_INTERNALRAM 0
SRVC var
TR_BAUD_CONFIG var
WCP_PROF 0

[sys.cfg]

DSP var
STD 6

[trace.cfg]

LAYER_DBG 0xFFFFFFFF
TRACE_LEVEL_FILTER 5