FreeCalypso > hg > fc-magnetite
view src/cs/layer1/tm_include/l1tm_ver.h @ 685:3fb7384e820d
tpudrv12.h: FCDEV3B goes back to being itself
A while back we had the idea of a FreeCalypso modem family whereby our
current fcdev3b target would some day morph into fcmodem, with multiple
FC modem family products, potentially either triband or quadband, being
firmware-compatible with each other and with our original FCDEV3B. But
in light of the discovery of Tango modules that earlier idea is now being
withdrawn: instead the already existing Tango hw is being adopted into
our FreeCalypso family.
Tango cannot be firmware-compatible with triband OM/FCDEV3B targets
because the original quadband RFFE on Tango modules is wired in TI's
original Leonardo arrangement. Because this Leonardo/Tango way is now
becoming the official FreeCalypso way of driving quadband RFFEs thanks
to the adoption of Tango into our FC family, our earlier idea of
extending FIC's triband RFFE control signals with TSPACT5 no longer makes
much sense - we will probably never produce any new hardware with that
once-proposed arrangement. Therefore, that triband-or-quadband FCFAM
provision is being removed from the code base, and FCDEV3B goes back to
being treated the same way as CONFIG_TARGET_GTAMODEM for RFFE control
purposes.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 24 Sep 2020 21:03:08 +0000 |
parents | 945cf7f506b2 |
children |
line wrap: on
line source
/************* Revision Controle System Header ************* * GSM Layer 1 software * L1TM_VER.H * * Filename l1tm_ver.h * Copyright 2003 (C) Texas Instruments * ************* Revision Controle System Header *************/ /*****************************/ /* Test mode version numbers */ /*****************************/ //#define TESTMODEVERSION 0x0300L // All previous TestMode versions pertain to // GGT Protocol version 2.0, which has been replaced // by version 3.0. //#define TESTMODEVERSION 0x0320L // AFC Params part of "rftw"; APCDEL intialized in "tm_init"; New fcn "l1tm_initialize_var" to switch to TestMode // Uplink-only tests loop count; RACH loop count; Dedicated mode Pass/Fail stats updated // New structure "T_TM_RETURN_ABBREV"; Continous TX/RX; New fcn "tmstats_auto_result_reset_loops"; // Corrected BSIC reporting problem; Power skip fcn implemented ("rftw/rftr 16"); A-F Loopback modes supported; // Chan. monitoring while in dedic. mode possible; FB26/D_BAMS_MEAS tasks enabled only with chan. monitoring; // New fcn "tmstats_mon_confirm"; RF struct incorporates new TX descriptor table; // AGC includes lna_off bit (least-significant bit); agc_, afc_ & adc_enable part of l1_config struct; // Variable number of guard bits in "l1tm_fill_burst"...... //#define TESTMODEVERSION 0x0321L // Implemented FRAME_NUMBER in l1tm_stats_read(). Timing advance takes effect immediately. stats_read reports 16 or 32 bit values only. // Only one uplink message sent. Some indices in l1tm_version_get implemented. AGC gain and lna_off set only once to save instruction cycles. // Cleaned up enums in l1_tm_types.h. Removed case STANDARD from rf_param_read. // Updated all argument types of testmode functions according to TM100 v3.2.1. Changed mem_read to support reception of page and // register values in one 16-bit value from PCTM. mem_read can read up to 124 bytes. Changed the TestMode primitive structure to include // only 2 generic ones plus mem_write and mem_read. //#define TESTMODEVERSION 0x0400L // REQ991: // - SIMULATION for test mode => new non-regression flow regress_tm.bat // - Rework of test mode state machines to make them independent from each other // - Rework of simulated upper layers (L3,CST) to be able to run L1 scenarios with TESTMODE=3 // Correction of BUG989, BUG990, BUG992 //#define TESTMODEVERSION 0x0401L // Merge with TM version 0x321 //#define TESTMODEVERSION 0x0402L // TM rework PART II //#define TESTMODEVERSION 0x0403L // Alignment with TM100 v.3.5.0 // Implementation of new functionality: single PM on monitor channel (rfe 15) //#define TESTMODEVERSION 0x0404L // Closed REQ01129: Implementation of GPRS test mode //#define TESTMODEVERSION 0x0405L // Alignment with SSA 5.3.3, // Correction of BUG2048, BUG2050, BUG2294, BUG2295 #define TESTMODEVERSION 0x0406L // REQ03410 //#define TMAPIVERSION 0x0350L // New: TM API version (TM100 version number) //#define TMAPIVERSION 0x0360L // TM100 change for GPRS test mode //#define TMAPIVERSION 0x0361L // tm patch 361 for SW version 520 //#define TMAPIVERSION 0x0362L // tm patch 362 for SW version 531 #define TMAPIVERSION 0x0370L // Multi-band support