FreeCalypso > hg > fc-magnetite
view doc/Freerunner-Howto @ 429:504b9cd42c37
components/bmi-tcs3: need -I for aci_dti_mng dir
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Mon, 22 Jan 2018 00:08:32 +0000 |
parents | 9399a83cb394 |
children | c9a65db8be4a |
line wrap: on
line source
The latest official firmware for Openmoko Neo1973 and Neo FreeRunner Calypso modems is moko13 as of this writing; moko13 is FreeCalypso Magnetite built for the gtamodem target in the l1reconst configuration. There have not been any changes in FC Magnetite since the moko13 release that affect the l1reconst config on the gtamodem target in any noticeable way, hence there is no need for a new release currently. However, we also have the new TCS2/TCS3 hybrid config in which the old version of the G23M protocol stack from Openmoko (binary libs only, no source) has been replaced with a newer version from TI's TCS3/LoCosto program, and this new version is full source. This hybrid firmware has not yet reached mokoN release status because some obscure features of the old ACI have not yet been reimplemented in the new one, but in every other way this hybrid fw is ready to be tested and exercised in real usage. The new hybrid fw for the gtamodem target can be built as follows: ./configure.sh gtamodem hybrid cd build-gtamodem-hybrid; make Then after enduring the very slow build, you can flash it with fc-loadtool: loadtool> flash erase 0 0x250000 loadtool> flash program-bin 0 fwimage.bin If you are brave enough to do the above, please let us know how this new modem firmware fares when driven by QtMoko or SHR on the AP - it would definitely be an adventure!