removing clutter: INIT_blob provision The lost init.c source was reconstructed from init.obj in 2017; prior to that reconstruction we were compiling main.lib from partial source: using the init module in blob form with various binary patches, but recompiling create_RVtasks.c from source so we could change RiViera SWE configuration. We've been using the fully reconstructed version of init.c since 2017, and now the old INIT_blob provision (which is not used by any config) is just extra noise in our targets/*.conf files. This commit removes all bits related to this provision, reducing clutter and making it easier to add new targets.

# This patch applies to the Init_Target() function in the init.obj module in
# main.lib; it is an example of how this code will need to be patched for
# running on our own future FreeCalypso hardware if we choose to use the same
# Spansion S71PL129NC0 flash+pSRAM MCP as used in the Pirelli DP-L10 and use
# the same memory timings as set by Pirelli's firmware.

[init.obj]

# value goes into nCS0, nCS1 and nCS3 config registers
.text 66 A4
# value goes into nCS2 config reg
.text 6C A4

# nop out the write into 0x02700000

.text 128 C0
.text 129 46