Lorekeeping: allow tpudrv-leonardo.lib on Leonardo/Tango Back in 2015 the Mother's idea was to produce a FreeCalypso development board that would be a clone of TI Leonardo, including the original quadband RFFE; one major additional stipulation was that this board needed to be able to run original unmodified TCS211-20070608 firmware with all blobs intact, with only minimal binary patches to main.lib and tpudrv.lib. The necessary patched libs were produced at that time in the tcs211-patches repository. That plan was changed and we produced FCDEV3B instead, with Openmoko's triband RFFE instead of Leonardo quadband, but when FC Magnetite started in 2016, a TPUDRV_blob= provision was still made, allowing the possibility of patching OM's tpudrv.lib for a restored Leonardo RFFE. Now in 2020 we have FC Tango which is essentially a verbatim clone of Leonardo core, including the original quadband RFFE. We have also deblobbed our firmware so much that we have absolutely no real need for a blob version of tpudrv.lib - but I thought it would be neat to put the ancient TPUDRV_blob= mechanism (classic config) to its originally intended use, just for the heck of it.

# This patch applies to the Init_Target() function in the init.obj module in
# main.lib; the present version is for making TCS211 run on the Pirelli.
# This patch sets the same memory and peripheral chip select timings and
# widths as Pirelli's fw.

[init.obj]

# value goes into nCS0, nCS1 and nCS3 config registers
.text 66 A4
# the nCS2 setting in our original blob is already correct for the Pirelli

# value goes into nCS4 config reg
.text 72 A7

# nop out the write into 0x02700000

.text 128 C0
.text 129 46