Lorekeeping: allow tpudrv-leonardo.lib on Leonardo/Tango Back in 2015 the Mother's idea was to produce a FreeCalypso development board that would be a clone of TI Leonardo, including the original quadband RFFE; one major additional stipulation was that this board needed to be able to run original unmodified TCS211-20070608 firmware with all blobs intact, with only minimal binary patches to main.lib and tpudrv.lib. The necessary patched libs were produced at that time in the tcs211-patches repository. That plan was changed and we produced FCDEV3B instead, with Openmoko's triband RFFE instead of Leonardo quadband, but when FC Magnetite started in 2016, a TPUDRV_blob= provision was still made, allowing the possibility of patching OM's tpudrv.lib for a restored Leonardo RFFE. Now in 2020 we have FC Tango which is essentially a verbatim clone of Leonardo core, including the original quadband RFFE. We have also deblobbed our firmware so much that we have absolutely no real need for a blob version of tpudrv.lib - but I thought it would be neat to put the ancient TPUDRV_blob= mechanism (classic config) to its originally intended use, just for the heck of it.

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1GTT_MSGTY.H
 *
 *        Filename l1gtt_msgty.h
 *  Copyright 2003 (C) Texas Instruments  
 *
 ************* Revision Controle System Header *************/

#if (L1_GTT == 1)

typedef struct
{
  UWORD8 loop_type;  // Type of loop to be closed
}
T_TST_CLOSE_GTT_LOOP_REQ;

typedef struct
{
  UWORD8  scen_type;  // 1 = input on CTM Tx, 2 = input on Baudot encoder
                      // SIMULATION ONLY: 3 = input on CTM Rx, 4 = input on Baudot decoder
  UWORD16 rate;       // Number of frames (4.615 ms) between each new character arrival
                      // for scen_type 3 and 4: GTT input file number
}
T_TST_START_GTT_TEST_REQ;

#endif // L1_GTT