FFS dev.c: added Spansion PL032J to the "generic" table With the discovery of first GTM900 and then Tango, it now appears that Openmoko was not the only manuf after all who kept TI's TCS211 firmware largely intact (as opposed to changing it beyond all recognition like Compal, Chi-Mei and BenQ did), thus we are now getting new "alien" targets on which we reuse the original manuf's FFS with IMEI and RF calibration tables as if it were native. On these targets we use the original device table for FFS, even though we previously thought that it would never apply to any target other than dsample, leonardo and gtamodem. We have previously added Samsung K5L33xxCAM (a new kind of multi-ID device) to the generic table to support its use in Huawei GTM900-B modules; now we got news that some slightly older GTM900-B specimen used S71PL032J instead, so we are now adding PL032J as well.

# This patch applies to the Init_Target() function in the init.obj module in
# main.lib; the present version is for making TCS211 run on the Pirelli.
# This patch sets the same memory and peripheral chip select timings and
# widths as Pirelli's fw.

[init.obj]

# value goes into nCS0, nCS1 and nCS3 config registers
.text 66 A4
# the nCS2 setting in our original blob is already correct for the Pirelli

# value goes into nCS4 config reg
.text 72 A7

# nop out the write into 0x02700000

.text 128 C0
.text 129 46