new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.

# This patch applies to the Init_Target() function in the init.obj module in
# main.lib; the present version is for making TCS211 run on the Pirelli.
# This patch sets the same memory and peripheral chip select timings and
# widths as Pirelli's fw.

[init.obj]

# value goes into nCS0, nCS1 and nCS3 config registers
.text 66 A4
# the nCS2 setting in our original blob is already correct for the Pirelli

# value goes into nCS4 config reg
.text 72 A7

# nop out the write into 0x02700000

.text 128 C0
.text 129 46