new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.

#!/bin/sh

set -e

if [ $# != 1 ]
then
	echo "Usage: %s config-name" 1>&2
	exit 1
fi

if [ ! -f "fflags-$1.h" ]
then
	echo "error: specified configuration is not known" 1>&2
	exit 1
fi

rm -rf tempout
mkdir tempout

# The arguments to ccdgen have been taken from TCS211 pdt_*.mak makefiles.

../toolwrap/ccdgen -h -m512 -a2 -ifflags-$1.h -otempout -Rpdf-mdf-list

echo "Converting from CRLF to UNIX line endings"

rm -rf cdginc-$1
mkdir cdginc-$1

# fromdos comes with Slackware, dunno about other distros
for i in `cat gen-file-list`
do
	fromdos < tempout/$i > cdginc-$1/$i
done