view cdg3/sap/fad.pdf @ 632:d968a3216ba0

new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 04 Jan 2020 19:27:41 +0000
parents c15047b3d00d
children
line wrap: on
line source

;********************************************************************************
;*** File           : fad.pdf
;*** Creation       : Wed Mar 11 09:58:02 CST 2009
;*** XSLT Processor : Apache Software Foundation / http://xml.apache.org/xalan-j / supports XSLT-Ver: 1
;*** Copyright      : (c) Texas Instruments AG, Berlin Germany 2002
;********************************************************************************
;*** Document Type  : Service Access Point Specification
;*** Document Name  : fad
;*** Document No.   : 8411.103.00.305
;*** Document Date  : 2002-04-22
;*** Document Status: BEING_PROCESSED
;*** Document Author: SLO
;********************************************************************************



PRAGMA 	SRC_FILE_TIME 	"Thu Nov 29 09:41:22 2007"
PRAGMA 	LAST_MODIFIED 	"2002-04-22"
PRAGMA 	ID_AND_VERSION 	"8411.103.00.305"



CONST 	DUMMY_FAD 	0 	; Dummy



VALTAB 	VAL_trans_rate
VAL 	300 	R_BCS 	"rate 300 bit/s"
VAL 	2400 	R_2400 	"rate 2400 bit/s"
VAL 	4800 	R_4800 	"rate 4800 bit/s"
VAL 	7200 	R_7200 	"rate 7200 bit/s"
VAL 	9600 	R_9600 	"rate 9600 bit/s"
VAL 	12000 	R_12000 	"rate 12000 bit/s"
VAL 	14400 	R_14400 	"rate 14400 bit/s"

VALTAB 	VAL_mode
VAL 	0x00 	MUX_OFF 	"ignore"
VAL 	0x01 	MUX_BCS 	"BCS data"
VAL 	0x02 	MUX_MSG 	"MSG  data"

VALTAB 	VAL_cause
VAL 	0xCC00 	ERR_REM_FAD 	"reserved"
VAL 	0xCC11 	ERR_REM_PREAMBLE 	"DATA received instead of PREAMBLE - Preamble too short"
VAL 	0xCC12 	ERR_REM_DATA_BCS 	"DATA received from remote modem during BCS phase"
VAL 	0xCC13 	ERR_REM_TRAIN_START 	"DATA received from remote modem at start of training"
VAL 	0xCC14 	ERR_REM_NO_TRAINING 	"DATA received from remote modem prior to training"
VAL 	0xCC15 	ERR_REM_TRAINING 	"DATA received from remote modem during training"
VAL 	0xCC16 	ERR_REM_MSG 	"DATA received from remote modem while sending MSG data"
VAL 	0xCC17 	ERR_REM_PREAMBLE_SHORT 	"PREAMBLE received from remote station too short"
VAL 	0xCC18 	ERR_REM_PREAMBLE_LONG 	"PREAMBLE received from remote station too long"
VAL 	0xCC19 	ERR_REM_IDENT 	"Incorrect identification from remote modem"
VAL 	0xCC20 	ERR_LOCAL_FAD 	"reserved"
VAL 	0xCC21 	ERR_LOCAL_BCS_RATE 	"BCS rate requested by local modem (MSG phase)"
VAL 	0xCC22 	ERR_LOCAL_MSG_RATE 	"MSG rate requested by local modem (BCS phase)"
VAL 	0xCC23 	ERR_LOCAL_DATA_NULL 	"DATA request received from T30 in NULL state"
VAL 	0xCC24 	ERR_LOCAL_DATA_BCS 	"DATA request received from T30 while receiving BCS data"
VAL 	0xCC25 	ERR_LOCAL_DATA_TCF_SND 	"DATA request received from T30 while sending TCF  data"
VAL 	0xCC26 	ERR_LOCAL_DATA_TCF_RCV 	"DATA request received from T30 while receiving TCF  data"
VAL 	0xCC27 	ERR_LOCAL_DATA_MSG 	"DATA request received from T30 while receiving MSG data"
VAL 	0xCC28 	ERR_LOCAL_DATA_UNDEF 	"DATA request received from T30 - state unknown"
VAL 	0xCC29 	ERR_LOCAL_DATA_MSG_UFL 	"DATA request not received from T30 - MSG-REC underflow"
VAL 	0xCC30 	ERR_LOCAL_IDENT 	"Incorrect identification from local modem"
VAL 	0xCC40 	ERR_OWN_FAD 	"reserved"
VAL 	0xCC41 	ERR_FAD_SUB_TRAIN 	"FAD in unknown substate during training"
VAL 	0xCC42 	ERR_FAD_SUB_TCF 	"FAD in unknown substate (TCF)"
VAL 	0xCC43 	ERR_FAD_SUB_MSG 	"FAD in unknown substate (MSG)"
VAL 	0xCC50 	ERR_GENERAL_FAD 	"reserved"
VAL 	0xCC51 	ERR_INVALID_DATA_RCV 	"invalid data received"
VAL 	0xCC52 	ERR_EMPTY_BUFFER 	"send/receive buffer is empty"
VAL 	0xCC52 	ERR_OVERFLOW_BCS_RCV 	"buffer  overflow while receiving BCS data"
VAL 	0xCCFF 	ERR_NOT_SET 	"error not set"




VAR 	trans_rate 	"transmission rate" 	S

VAL 	@p_fad - VAL_trans_rate@ 	

VAR 	final 	"final flag" 	B


VAR 	l_buf 	"length of content in bits" 	S


VAR 	o_buf 	"offset of content in bits" 	S


VAR 	buf 	"buffer content" 	B


VAR 	frames_per_prim 	"no. of frames per primitive" 	S


VAR 	mode 	"receive mode" 	B

VAL 	@p_fad - VAL_mode@ 	

VAR 	cause 	"error cause" 	S

VAL 	@p_fad - VAL_cause@ 	

VAR 	ratio 	"percentage of correct TCF received" 	B


VAR 	reserved 	"Reserved" 	S


VAR 	buf_size_rx 	"buffer size RX" 	S


VAR 	buf_size_tx 	"buffer size TX" 	S





COMP 	sdu 	 "Service Data Unit"
{
 	l_buf 	 ; length of content in bits
 	o_buf 	 ; offset of content in bits
 	buf 	[1] 	 ; buffer content
}






; FAD_ACTIVATE_REQ 	0x80000013
; FAD_DEACTIVATE_REQ 	0x80010013
; FAD_MODIFY_REQ 	0x80020013
; FAD_DATA_REQ 	0x80030013
; FAD_DATA_IND 	0x80004013
; FAD_DATA_CNF 	0x80014013
; FAD_SND_TCF_REQ 	0x80040013
; FAD_SND_TCF_CNF 	0x80024013
; FAD_RCV_TCF_REQ 	0x80050013
; FAD_RCV_TCF_CNF 	0x80034013
; FAD_READY_REQ 	0x80060013
; FAD_READY_IND 	0x80044013
; FAD_IGNORE_REQ 	0x80070013
; FAD_MUX_IND 	0x80054013
; FAD_ERROR_IND 	0x80064013
; FAD_DEACTIVATE_CNF 	0x80074013
; FAD_ACTIVATE_CNF 	0x80084013



PRIM 	FAD_ACTIVATE_REQ 	0x80000013
{
 	trans_rate 	 ; transmission rate
 	frames_per_prim 	 ; frames per primitive
}






PRIM 	FAD_DEACTIVATE_REQ 	0x80010013
{
}






PRIM 	FAD_MODIFY_REQ 	0x80020013
{
 	trans_rate 	 ; transmission rate
}






PRIM 	FAD_DATA_REQ 	0x80030013
{
 	final 	 ; final flag
 	trans_rate 	 ; transmission rate
 	sdu 	 ; service data unit
}






PRIM 	FAD_DATA_IND 	0x80004013
{
 	final 	 ; final flag
 	reserved 	 ; reserved
 	sdu 	 ; service data unit
}






PRIM 	FAD_DATA_CNF 	0x80014013
{
}






PRIM 	FAD_SND_TCF_REQ 	0x80040013
{
 	trans_rate 	 ; transmission rate
}






PRIM 	FAD_SND_TCF_CNF 	0x80024013
{
}






PRIM 	FAD_RCV_TCF_REQ 	0x80050013
{
 	trans_rate 	 ; transmission rate
}






PRIM 	FAD_RCV_TCF_CNF 	0x80034013
{
 	ratio 	 ; TCF ratio (%)
}






PRIM 	FAD_READY_REQ 	0x80060013
{
}






PRIM 	FAD_READY_IND 	0x80044013
{
}






PRIM 	FAD_IGNORE_REQ 	0x80070013
{
}






PRIM 	FAD_MUX_IND 	0x80054013
{
 	mode 	 ; receive mode
}






PRIM 	FAD_ERROR_IND 	0x80064013
{
 	cause 	 ; error cause
}






PRIM 	FAD_DEACTIVATE_CNF 	0x80074013
{
}






PRIM 	FAD_ACTIVATE_CNF 	0x80084013
{
 	buf_size_rx 	 ; buffer size RX
 	buf_size_tx 	 ; buffer size TX
}