new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.

#ifndef __L1SW_CFG__
#define __L1SW_CFG__
#define AMR 1
#define CUST 0
#define DCO_ALGO 0
#define IDS 0
#define L1_12NEIGH 1
#define L1_EOTD 0
#define L1_EOTD_QBIT_ACC 0
#define L1_GPRS 0
#define L1_GTT 0
#define L1_MIDI 0
#define L1_VOICE_MEMO_AMR 1
#define MELODY_E2 1
#define OP_L1_STANDALONE 0
#define OP_RIV_AUDIO 1
#define ORDER2_TX_TEMP_CAL 1
#define RAZ_VULSWITCH_REGAUDIO 0
#define SECURITY 0
#define SPEECH_RECO 1
#define TESTMODE 1
#define TRACE_TYPE 4
#define VCXO_ALGO 1
#endif /* __L1SW_CFG__ */