new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1P_PROTO.H
 *
 *        Filename l1p_prot.h
 *  Copyright 2003 (C) Texas Instruments  
 *
 ************* Revision Controle System Header *************/


/**************************************/
/* Prototypes for L1 ASYNCH task      */
/**************************************/
void  l1pa_idle_paging_process(xSignalHeaderRec *msg); 

/**************************************/
/* Prototypes for l1S packet task,    */
/* embedded in CS code                */
/**************************************/


/**************************************/
/* Prototypes for L1 COMPLEX functions*/
/**************************************/