FreeCalypso > hg > fc-magnetite
view src/cs/layer1/p_include/l1p_vare.h @ 632:d968a3216ba0
new tangomdm build target
TCS211/Magnetite built for target leonardo runs just fine on the Tango-based
Caramel board, but a more proper tangomdm build target is preferable in order
to better market these Tango modems to prospective commercial customers. The
only differences are in GPIO and MCSI config:
* MCSI is enabled in the tangomdm build config.
* GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms
it can be used for anything. On Caramel boards this GPIO should be
configured as an output driving high.
* GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango
platforms it can be used for anything. On Caramel boards this GPIO should be
configured as an output, either high or low is OK.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Sat, 04 Jan 2020 19:27:41 +0000 |
| parents | 945cf7f506b2 |
| children |
line wrap: on
line source
/************* Revision Controle System Header ************* * GSM Layer 1 software * L1P_VAREX.H * * Filename l1p_vare.h * Copyright 2003 (C) Texas Instruments * ************* Revision Controle System Header *************/ #ifdef L1P_ASYN_C #if (LONG_JUMP == 3) #pragma DATA_SECTION(l1ps,".l1s_global") #pragma DATA_SECTION(l1pa_l1ps_com,".l1s_global") #pragma DATA_SECTION(l1ps_macs_com,".l1s_global") #pragma DATA_SECTION(l1ps_dsp_com,".l1s_global") #endif // Global Packet L1A structure T_L1PA_GLOBAL l1pa; // Global Packet L1S structure T_L1PS_GLOBAL l1ps; // Common structure between L1A and L1S in packet mode T_L1PA_L1PS_COM l1pa_l1ps_com; // Communication between L1S and MAC-S in packet mode T_L1PS_MACS_COM l1ps_macs_com; // MCU / DSP interface T_L1PS_DSP_COM l1ps_dsp_com; #else extern T_L1PA_GLOBAL l1pa; extern T_L1PS_GLOBAL l1ps; extern T_L1PA_L1PS_COM l1pa_l1ps_com; extern T_L1PS_DSP_COM l1ps_dsp_com; extern T_L1PS_MACS_COM l1ps_macs_com; #endif