view src/g23m-aci/aci/psa_l2r.h @ 632:d968a3216ba0

new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 04 Jan 2020 19:27:41 +0000
parents 53929b40109c
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  GSM-PS (6147)
|  Modul   :  PSA_L2R
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Definitions for the protocol stack adapter
|             Layer 2 Relay ( L2R )
+----------------------------------------------------------------------------- 
*/ 

#ifndef PSA_L2R_H
#define PSA_L2R_H

/*==== CONSTANTS ==================================================*/

typedef enum
{
  L2R_DEACTIVATED = 0,
  L2R_ACTIVATE,
  L2R_CONNECT,
  L2R_CONNECTED,
  L2R_ENABLE,
  L2R_ENABLED,
//  L2R_DISABLE,
  L2R_DETACH,
  L2R_DISCONNECT,
  L2R_DEACTIVATE,
  L2R_ESCAPE
} T_L2R_STATE;


/*==== TYPES ======================================================*/

typedef struct
{
  UBYTE  rlp_vers;                /* L2R_XID_IND */
  USHORT k_ms_iwf;                /* L2R_ACTIVATE_REQ, L2R_XID_IND */
  USHORT k_iwf_ms;
  UBYTE  t1;
  UBYTE  t2;
  UBYTE  n2;
  UBYTE  pt;
  UBYTE  p0;
  USHORT p1;
  UBYTE  p2;
  UBYTE  uil2p;
  UBYTE  rate;
  USHORT err_cause;               /* L2R_ERROR_IND */ 
  ULONG  error_rate;              /* L2R_STATISTIC_IND */
  USHORT reset;                   /* L2R_RESET_IND */
} T_L2R_SET_PRM;

typedef struct L2RShrdParm
{
  UBYTE         owner;
  UBYTE         state;
  UBYTE         uart_conn;
  T_L2R_SET_PRM set_prm[OWN_SRC_MAX];
  T_L2R_SET_PRM set_prm_use;
} T_L2R_SHRD_PRM;

typedef struct L2RTstPrmRef
{
  const char * key;               /* keyword string */
  UBYTE  id;                      /* corresponding id */
} L2R_TSTPRM_REF;

/*==== PROTOTYPES =================================================*/

#ifdef DTI
GLOBAL SHORT psaL2R_Enable( T_DTI_CONN_LINK_ID  link_id, UBYTE peer );
#endif /* DTI */

GLOBAL SHORT psaL2R_Activate( UBYTE srcId );
GLOBAL SHORT psaL2R_Deactivate( void );
void  psaL2R_Init (void);

GLOBAL SHORT psaL2R_ESC( UBYTE src_id );

/*==== EXPORT =====================================================*/

#ifdef PSA_L2RF_C

GLOBAL T_L2R_SHRD_PRM l2rShrdPrm;

#else

EXTERN T_L2R_SHRD_PRM l2rShrdPrm;

#endif /* PSA_L2RF_C */


#endif /* PSA_L2R_H */

/*==== EOF =======================================================*/