FreeCalypso > hg > fc-magnetite

view src/g23m-aci/aci_ext/aci_ext_pers_cus.h @ 632:d968a3216ba0

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 04 Jan 2020 19:27:41 +0000
parents 53929b40109c
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  
|  Modul   :  J:\g23m-aci\aci_ext\aci_ext_pers_cus.h
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  
+----------------------------------------------------------------------------- 
*/ 

/*
   This is the initial setup for the customisation of MMI security. 
   Additional personalisation will be added at a later stage.
 */
T_ACI_PERS_MMI_DATAS MMI_personalisation_status =
{
   0x02,                // State disabled no pin required
   0x00,                // Count
   0x03,                // Max Count
   0x05,                // Pwd length
   0x21,0x43,0xF5,      // Current code BCD
   0x21,0x43,0xF5       // Original code BCD
};
   
#ifdef SIM_PERS

T_SEC_DRV_CATEGORY *personalisation_nw;

T_SEC_DRV_CATEGORY *personalisation_ns;

T_SEC_DRV_CATEGORY *personalisation_sp;

T_SEC_DRV_CATEGORY *personalisation_cp;

T_SEC_DRV_CATEGORY *personalisation_sim;

T_SEC_DRV_CATEGORY *personalisation_bnw;

T_SEC_DRV_CATEGORY *personalisation_first_sim;
#endif