FreeCalypso > hg > fc-magnetite

view src/g23m-aci/uart/uart_drxs.h @ 632:d968a3216ba0

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 04 Jan 2020 19:27:41 +0000
parents 53929b40109c
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  
|  Modul   :  
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Definitions for uart_drxs.c 
+----------------------------------------------------------------------------- 
*/ 

#ifndef UART_DRXS_H
#define UART_DRXS_H


EXTERN void sig_ker_drx_ready_mode_req (UBYTE dlc_instance);

EXTERN void sig_ker_drx_dead_mode_req (void);

EXTERN void sig_ker_drx_enable_req (void);

EXTERN void sig_ker_drx_disable_req (void);

EXTERN void sig_tx_drx_sending_req (void);

EXTERN void sig_tx_drx_data_sent_req (T_desc2* rest_data, USHORT pos);

EXTERN void sig_ker_drx_set_dti_peer_req (USHORT tui_peer, 
                                          T_HANDLE peer_handle, 
                                          UBYTE c_id);

#ifdef DTILIB
EXTERN void sig_ker_drx_set_dtilib_peer_req (void);
#ifdef DTI2
EXTERN void sig_ker_drx_disconnected_mode_req(void);
#endif /* DTI2 */
#endif /* DTILIB */

EXTERN void sig_ker_drx_flush_req (void);

#endif /* !UART_DRXS_H */