FreeCalypso > hg > fc-magnetite
view src/g23m-aci/uart/uart_kers.h @ 632:d968a3216ba0
new tangomdm build target
TCS211/Magnetite built for target leonardo runs just fine on the Tango-based
Caramel board, but a more proper tangomdm build target is preferable in order
to better market these Tango modems to prospective commercial customers. The
only differences are in GPIO and MCSI config:
* MCSI is enabled in the tangomdm build config.
* GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms
it can be used for anything. On Caramel boards this GPIO should be
configured as an output driving high.
* GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango
platforms it can be used for anything. On Caramel boards this GPIO should be
configured as an output, either high or low is OK.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Sat, 04 Jan 2020 19:27:41 +0000 |
parents | 53929b40109c |
children |
line wrap: on
line source
/* +----------------------------------------------------------------------------- | Project : | Modul : +----------------------------------------------------------------------------- | Copyright 2002 Texas Instruments Berlin, AG | All rights reserved. | | This file is confidential and a trade secret of Texas | Instruments Berlin, AG | The receipt of or possession of this file does not convey | any rights to reproduce or disclose its contents or to | manufacture, use, or sell anything it may describe, in | whole, or in part, without the specific written consent of | Texas Instruments Berlin, AG. +----------------------------------------------------------------------------- | Purpose : Definitions for uart_kers.c +----------------------------------------------------------------------------- */ #ifndef UART_KERS_H #define UART_KERS_H EXTERN void sig_drx_ker_line_states_ind(UBYTE dlc_instance, UBYTE st_flow, UBYTE st_line_sa, UBYTE st_line_sb, USHORT st_break_len); EXTERN void sig_dtx_ker_enable_ind(UBYTE dlc_instance); EXTERN void sig_dtx_ker_disable_ind(UBYTE dlc_instance); EXTERN void sig_dtx_ker_escape_detected_ind(U8 dlc_instance); EXTERN void sig_any_ker_flushed_ind(UBYTE dlc_instance); EXTERN void sig_tx_ker_flushed_ind(void); EXTERN void sig_tx_ker_sending_ind (void); EXTERN void sig_tx_ker_data_sent_ind (T_desc2* rest_data, USHORT write_pos); EXTERN void sig_rx_ker_receiving_ind (void); EXTERN void sig_rx_ker_data_received_ind (T_desc2* received_data, USHORT write_pos); EXTERN void sig_rx_ker_line_states_ind (ULONG line_states); EXTERN void sig_rt_ker_timeout_t1_ind (void); EXTERN void sig_rt_ker_timeout_t2_ind (void); EXTERN void sig_rt_ker_timeout_t3_ind (void); EXTERN void sig_rt_ker_timeout_tesd_ind (void); EXTERN void sig_dti_ker_connection_closed_ind (U8 dlc_instance); #endif /* !UART_KERS_H */