FreeCalypso > hg > fc-magnetite

view src/g23m-aci/uart/uart_rts.h @ 632:d968a3216ba0

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
new tangomdm build target TCS211/Magnetite built for target leonardo runs just fine on the Tango-based Caramel board, but a more proper tangomdm build target is preferable in order to better market these Tango modems to prospective commercial customers. The only differences are in GPIO and MCSI config: * MCSI is enabled in the tangomdm build config. * GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output driving high. * GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango platforms it can be used for anything. On Caramel boards this GPIO should be configured as an output, either high or low is OK.
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 04 Jan 2020 19:27:41 +0000
parents 53929b40109c
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  
|  Modul   :  
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Definitions for uart_rts.c 
+----------------------------------------------------------------------------- 
*/ 

#ifndef UART_RTS_H
#define UART_RTS_H


EXTERN void sig_ker_rt_parameters_req ( UBYTE t1, UBYTE t2, UBYTE t3);

EXTERN void sig_ker_rt_start_t1_req (void);

EXTERN void sig_ker_rt_start_t2_req (void);

EXTERN void sig_ker_rt_start_t3_req (void);

EXTERN void sig_dtx_rt_start_tesd_req (T_TIME tesd_value);

EXTERN void sig_ker_rt_stop_t1_req (void);

EXTERN void sig_ker_rt_stop_t2_req (void);

EXTERN void sig_ker_rt_stop_t3_req (void);

EXTERN void sig_dtx_rt_stop_tesd_req (void);

#endif /* !UART_RTS_H */