FreeCalypso > hg > fc-magnetite
view src/gpf2/tst/drv/stack1_Serial.h @ 632:d968a3216ba0
new tangomdm build target
TCS211/Magnetite built for target leonardo runs just fine on the Tango-based
Caramel board, but a more proper tangomdm build target is preferable in order
to better market these Tango modems to prospective commercial customers. The
only differences are in GPIO and MCSI config:
* MCSI is enabled in the tangomdm build config.
* GPIO 1 is loudspeaker amplifier control on Leonardo, but on Tango platforms
it can be used for anything. On Caramel boards this GPIO should be
configured as an output driving high.
* GPIO 2 needs to be configured as Calypso input on Leonardo, but on Tango
platforms it can be used for anything. On Caramel boards this GPIO should be
configured as an output, either high or low is OK.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Sat, 04 Jan 2020 19:27:41 +0000 |
parents | cd37d228dae0 |
children |
line wrap: on
line source
/*============================================================================= * Copyright 1996-2001 Texas Instruments Inc. All rights reserved. */ #ifndef STACK1_SERIAL_HEADER #define STACK1_SERIAL_HEADER //#include "puf_PrimHdr.h" /*============================================================================= * Description: */ //typedef struct{ // Puf_PrimHdr primHdr; //}Stack1_Serial_RxInd; typedef void (*SERIAL_CALLBACK_FUNC)(void); /*=========================================================================== * Description: * Install the Uart interrupt handlers and initialize the Uart. */ int stack1_Serial_PowerUp( SERIAL_CALLBACK_FUNC callback ); /*=========================================================================== * Description: * Copy the data from the Rx buffer into the passed in buffer. If there * aren't dataLen bytes in the Rx buffer all the bytes currently in the rx * buffer are returned. */ unsigned long stack1_Serial_receiveData( unsigned char *dataPtr, unsigned long dataLen ); /*=========================================================================== * Description: * Copy the data to be transmitted into the Tx Buffer and enable the Uart Tx * interrupt. If the Tx buffer is full, discard the data and return a buffer * full indication. */ int stack1_Serial_sendData( unsigned char *dataPtr, unsigned long dataLen ); #endif