FreeCalypso > hg > fc-magnetite
view cdg211/cdginc/p_mdl.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 56abf6cf8a0b |
children |
line wrap: on
line source
/* +--------------------------------------------------------------------------+ | PROJECT : PROTOCOL STACK | | FILE : p_mdl.h | | SOURCE : "__out__\g23m_dfile\prim\mdl.pdf" | | LastModified : "2002-04-19" | | IdAndVersion : "6147.111.97.101" | | SrcFileTime : "Mon Nov 24 15:49:58 2003" | | Generated by CCDGEN_2.5.5 on Fri Jun 08 13:59:15 2007 | | !!DO NOT MODIFY!!DO NOT MODIFY!!DO NOT MODIFY!! | +--------------------------------------------------------------------------+ */ /* PRAGMAS * PREFIX : NONE * COMPATIBILITY_DEFINES : NO (require PREFIX) * ALWAYS_ENUM_IN_VAL_FILE: NO * ENABLE_GROUP: NO * CAPITALIZE_TYPENAME: NO */ #ifndef P_MDL_H #define P_MDL_H #define CDG_ENTER__P_MDL_H #define CDG_ENTER__FILENAME _P_MDL_H #define CDG_ENTER__P_MDL_H__FILE_TYPE CDGINC #define CDG_ENTER__P_MDL_H__LAST_MODIFIED _2002_04_19 #define CDG_ENTER__P_MDL_H__ID_AND_VERSION _6147_111_97_101 #define CDG_ENTER__P_MDL_H__SRC_FILE_TIME _Mon_Nov_24_15_49_58_2003 #include "CDG_ENTER.h" #undef CDG_ENTER__P_MDL_H #undef CDG_ENTER__FILENAME #include "p_mdl.val" /* * End of substructure section, begin of primitive definition section */ #ifndef __T_MDL_ERROR_IND__ #define __T_MDL_ERROR_IND__ /* * * CCDGEN:WriteStruct_Count==1349 */ typedef struct { U8 ch_type; /*< 0: 1> channel type */ U8 sapi; /*< 1: 1> service access point identifier */ U8 cs; /*< 2: 1> error cause */ U8 _align0; /*< 3: 1> alignment */ } T_MDL_ERROR_IND; #endif #ifndef __T_MDL_RELEASE_REQ__ #define __T_MDL_RELEASE_REQ__ /* * * CCDGEN:WriteStruct_Count==1350 */ typedef struct { U8 ch_type; /*< 0: 1> channel type */ U8 sapi; /*< 1: 1> service access point identifier */ U8 _align0; /*< 2: 1> alignment */ U8 _align1; /*< 3: 1> alignment */ } T_MDL_RELEASE_REQ; #endif #include "CDG_LEAVE.h" #endif