FreeCalypso > hg > fc-magnetite
view cdg211/cdginc/p_ph.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 56abf6cf8a0b |
children |
line wrap: on
line source
/* +--------------------------------------------------------------------------+ | PROJECT : PROTOCOL STACK | | FILE : p_ph.h | | SOURCE : "__out__\g23m_dfile\prim\ph.pdf" | | LastModified : "2001-10-26" | | IdAndVersion : "6147.112.01.100" | | SrcFileTime : "Tue May 18 17:03:14 2004" | | Generated by CCDGEN_2.5.5 on Fri Jun 08 13:59:15 2007 | | !!DO NOT MODIFY!!DO NOT MODIFY!!DO NOT MODIFY!! | +--------------------------------------------------------------------------+ */ /* PRAGMAS * PREFIX : NONE * COMPATIBILITY_DEFINES : NO (require PREFIX) * ALWAYS_ENUM_IN_VAL_FILE: NO * ENABLE_GROUP: NO * CAPITALIZE_TYPENAME: NO */ #ifndef P_PH_H #define P_PH_H #define CDG_ENTER__P_PH_H #define CDG_ENTER__FILENAME _P_PH_H #define CDG_ENTER__P_PH_H__FILE_TYPE CDGINC #define CDG_ENTER__P_PH_H__LAST_MODIFIED _2001_10_26 #define CDG_ENTER__P_PH_H__ID_AND_VERSION _6147_112_01_100 #define CDG_ENTER__P_PH_H__SRC_FILE_TIME _Tue_May_18_17_03_14_2004 #include "CDG_ENTER.h" #undef CDG_ENTER__P_PH_H #undef CDG_ENTER__FILENAME #include "p_ph.val" #include "p_mphc.h" /* * End of substructure section, begin of primitive definition section */ #ifndef __T_PH_READY_TO_SEND__ #define __T_PH_READY_TO_SEND__ /* * * CCDGEN:WriteStruct_Count==1823 */ typedef struct { U8 ch_type; /*< 0: 1> Layer 2 channel-type */ U8 _align0; /*< 1: 1> alignment */ U8 _align1; /*< 2: 1> alignment */ U8 _align2; /*< 3: 1> alignment */ } T_PH_READY_TO_SEND; #endif #ifndef __T_PH_DATA_REQ__ #define __T_PH_DATA_REQ__ /* * * CCDGEN:WriteStruct_Count==1824 */ typedef struct { U8 ch_type; /*< 0: 1> Layer 2 channel-type */ U8 dummy; /*< 1: 1> dummy not used */ U8 _align0; /*< 2: 1> alignment */ U8 _align1; /*< 3: 1> alignment */ T_sdu sdu; /*< 4: ? > message unit */ } T_PH_DATA_REQ; #endif #ifndef __T_PH_TRACE_IND__ #define __T_PH_TRACE_IND__ /* * * CCDGEN:WriteStruct_Count==1825 */ typedef struct { U8 dummy; /*< 0: 1> dummy not used */ U8 _align0; /*< 1: 1> alignment */ U8 _align1; /*< 2: 1> alignment */ U8 _align2; /*< 3: 1> alignment */ } T_PH_TRACE_IND; #endif #include "CDG_LEAVE.h" #endif