view cdg3/cdginc-locosto/uicc.intf @ 680:ee3ac8c617cb

armio.c: set GPIO2 output high initially On TI-canonical platforms GPIO2 is DCD modem control output. In TI's original code the AI_InitIOConfig() function called from Init_Target() would configure GPIO2 as an output and set the initial output value to low, but then the init code in uartfax.c called from Init_Serial_Flows() would immediately change it to high, corresponding to DCD not asserted. The result is a momentary asserted-state glitch on the DCD output. The present change eliminates this glitch, setting DCD output to not-asserted initially like it should be.
author Mychaela Falconia <falcon@freecalypso.org>
date Thu, 25 Jun 2020 03:17:43 +0000
parents c15047b3d00d
children
line wrap: on
line source

/*
+--------------------------------------------------------------------------+
| PROJECT : PROTOCOL STACK                                                 |
| FILE    : uicc.intf                                                      |
| SOURCE  : "sap\8010_136_SIMDRV_SAP.pdf"                                  |
| LastModified : "2004-06-10"                                              |
| IdAndVersion : "8010.136.03.009"                                         |
| SrcFileTime  : "Thu Nov 29 09:27:56 2007"                                |
| Generated by CCDGEN_2.5.5A on Thu Sep 25 09:18:53 2014                   |
|           !!DO NOT MODIFY!!DO NOT MODIFY!!DO NOT MODIFY!!                |
+--------------------------------------------------------------------------+
*/

Interface =
{
  structHdrFile = "uicc.h";
  inputs =
  {
    SIMDRV_DUMMY =
    {
      primNum = 0x80FF009A;
      primStruct = Uicc_Dummy;
      comment = "";
    };
  };
  outputs = {
  };
};