FreeCalypso > hg > fc-magnetite
view cfg-headers/fax-and-data/l1sw.cfg @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 84d81d34efa2 |
children |
line wrap: on
line source
#ifndef __L1SW_CFG__ #define __L1SW_CFG__ #define AMR 1 #define CUST 0 #define DCO_ALGO 0 #define IDS 1 #define L1_12NEIGH 1 #define L1_EOTD 0 #define L1_EOTD_QBIT_ACC 0 #define L1_GPRS 0 #define L1_GTT 0 #define L1_MIDI 0 #define L1_VOICE_MEMO_AMR 1 #define MELODY_E2 1 #define OP_L1_STANDALONE 0 #define OP_RIV_AUDIO 1 #define ORDER2_TX_TEMP_CAL 1 #define RAZ_VULSWITCH_REGAUDIO 0 #define SECURITY 0 #define SPEECH_RECO 1 #define TESTMODE 1 #define TRACE_TYPE 4 #define VCXO_ALGO 1 #endif /* __L1SW_CFG__ */