FreeCalypso > hg > fc-magnetite
view src/cs/layer1/include/l1_types.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 945cf7f506b2 |
children |
line wrap: on
line source
/************* Revision Controle System Header ************* * GSM Layer 1 software * L1_TYPES.H * * Filename l1_types.h * Copyright 2003 (C) Texas Instruments * ************* Revision Controle System Header *************/ //-------------------------------------- // Basic DATA types used along L1 code. //-------------------------------------- #if !defined (BOOL_FLAG) #define BOOL_FLAG typedef unsigned char BOOL; #endif #if !defined (NUCLEUS) && !defined CHAR_FLAG #define CHAR_FLAG typedef char CHAR; #endif typedef unsigned char UWORD8; typedef signed char WORD8; typedef unsigned short UWORD16; typedef short WORD16; typedef unsigned long UWORD32; typedef long WORD32; //-------------------------------------- typedef volatile UWORD16 API; typedef volatile WORD16 API_SIGNED;