FreeCalypso > hg > fc-magnetite
view src/cs/services/audio/audio_var_i.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Thu, 25 Jun 2020 03:17:43 +0000 |
| parents | 838eeafb0051 |
| children |
line wrap: on
line source
/********************************************************************************/ /* */ /* File Name: audio_var_i.h */ /* */ /* Purpose: This header contains the global variables */ /* that are used by the AUDIO layer. */ /* */ /* Note: */ /* None. */ /* */ /* Revision History: */ /* 11 May 01 Francois Mazard - Stephanie Gerthoux Create */ /* */ /* (C) Copyright 2001 by Texas Instruments Incorporated, All Rights Reserved. */ /* */ /********************************************************************************/ #ifndef _AUDIO_VAR_I_H_ #define _AUDIO_VAR_I_H_ #ifdef __cplusplus extern "C" { #endif /* Define a pointer to the Global Environment Control block */ extern T_AUDIO_ENV_CTRL_BLK *p_audio_gbl_var; #ifdef __cplusplus } #endif #endif /* _AUDIO_VAR_I_ */
