FreeCalypso > hg > fc-magnetite
view src/g23m-aci/uart/uart_drxp.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 53929b40109c |
children |
line wrap: on
line source
/* +----------------------------------------------------------------------------- | Project : | Modul : +----------------------------------------------------------------------------- | Copyright 2002 Texas Instruments Berlin, AG | All rights reserved. | | This file is confidential and a trade secret of Texas | Instruments Berlin, AG | The receipt of or possession of this file does not convey | any rights to reproduce or disclose its contents or to | manufacture, use, or sell anything it may describe, in | whole, or in part, without the specific written consent of | Texas Instruments Berlin, AG. +----------------------------------------------------------------------------- | Purpose : Definitions for uart_drxp.c +----------------------------------------------------------------------------- */ #ifndef UART_DRXP_H #define UART_DRXP_H EXTERN void drx_dti_data_test_req ( T_DTI2_DATA_TEST_REQ *dti_data_test_req ); EXTERN void drx_dti_data_req ( T_DTI2_DATA_REQ *dti_data_req ); #ifdef DTILIB EXTERN void sig_dti_drx_data_received_ind(T_DTI2_DATA_IND *dti_data2_ind); #endif /* DTILIB */ #endif /* !UART_DRXP_H */