FreeCalypso > hg > fc-magnetite
view src/g23m-aci/uart/uart_drxs.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | 53929b40109c |
children |
line wrap: on
line source
/* +----------------------------------------------------------------------------- | Project : | Modul : +----------------------------------------------------------------------------- | Copyright 2002 Texas Instruments Berlin, AG | All rights reserved. | | This file is confidential and a trade secret of Texas | Instruments Berlin, AG | The receipt of or possession of this file does not convey | any rights to reproduce or disclose its contents or to | manufacture, use, or sell anything it may describe, in | whole, or in part, without the specific written consent of | Texas Instruments Berlin, AG. +----------------------------------------------------------------------------- | Purpose : Definitions for uart_drxs.c +----------------------------------------------------------------------------- */ #ifndef UART_DRXS_H #define UART_DRXS_H EXTERN void sig_ker_drx_ready_mode_req (UBYTE dlc_instance); EXTERN void sig_ker_drx_dead_mode_req (void); EXTERN void sig_ker_drx_enable_req (void); EXTERN void sig_ker_drx_disable_req (void); EXTERN void sig_tx_drx_sending_req (void); EXTERN void sig_tx_drx_data_sent_req (T_desc2* rest_data, USHORT pos); EXTERN void sig_ker_drx_set_dti_peer_req (USHORT tui_peer, T_HANDLE peer_handle, UBYTE c_id); #ifdef DTILIB EXTERN void sig_ker_drx_set_dtilib_peer_req (void); #ifdef DTI2 EXTERN void sig_ker_drx_disconnected_mode_req(void); #endif /* DTI2 */ #endif /* DTILIB */ EXTERN void sig_ker_drx_flush_req (void); #endif /* !UART_DRXS_H */