FreeCalypso > hg > fc-magnetite

view src/g23m-gprs/gmm/gmm_rxf.h @ 680:ee3ac8c617cb

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
armio.c: set GPIO2 output high initially On TI-canonical platforms GPIO2 is DCD modem control output. In TI's original code the AI_InitIOConfig() function called from Init_Target() would configure GPIO2 as an output and set the initial output value to low, but then the init code in uartfax.c called from Init_Serial_Flows() would immediately change it to high, corresponding to DCD not asserted. The result is a momentary asserted-state glitch on the DCD output. The present change eliminates this glitch, setting DCD output to not-asserted initially like it should be.
author Mychaela Falconia <falcon@freecalypso.org>
date Thu, 25 Jun 2020 03:17:43 +0000
parents 219afcfc6250
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  GPRS (8441)
|  Modul   :  gmm_rxf.h
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Definitions for gmm_rxf.c 
+----------------------------------------------------------------------------- 
*/ 


#ifndef GMM_RXF_H
#define GMM_RXF_H




EXTERN void rxgmm_init ( void );
EXTERN void rx_gmm_status ( UBYTE cause );


#endif /* !GMM_RXF_H */