view src/g23m-gsm/ss/cus_ss.h @ 680:ee3ac8c617cb

armio.c: set GPIO2 output high initially On TI-canonical platforms GPIO2 is DCD modem control output. In TI's original code the AI_InitIOConfig() function called from Init_Target() would configure GPIO2 as an output and set the initial output value to low, but then the init code in uartfax.c called from Init_Serial_Flows() would immediately change it to high, corresponding to DCD not asserted. The result is a momentary asserted-state glitch on the DCD output. The present change eliminates this glitch, setting DCD output to not-asserted initially like it should be.
author Mychaela Falconia <falcon@freecalypso.org>
date Thu, 25 Jun 2020 03:17:43 +0000
parents 27a4235405c6
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  GSM-PS (6147)
|  Modul   :  CUS_SS
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Custom dependent definitions for SS of the
|             mobile station
|             
|             Use this header for definitions to integrate the
|             protocol stack entity SS in your target system !
+----------------------------------------------------------------------------- 
*/ 

#ifndef CUS_SS_H
#define CUS_SS_H

/*==== CONSTANTS ==================================================*/
 /*
 * VSI_CALLER
 *
 * Description :  For multithread applications the constant VSI_CALLER
 *                must be defined to identify the calling thread of the
 *                VSI-Interface. This must be done correponding to the
 *                type of T_VSI_CALLER in VSI.H. The comma symbol is
 *                neccessary because the vsi-functions are called
 *                like this vsi_xxx (VSI_CALLER par2, par3 ...)
 */
#if defined (NEW_FRAME)
#ifdef OPTION_MULTITHREAD
#define VSI_CALLER ss_handle,
#define VSI_CALLER_SINGLE ss_handle
#else
#define VSI_CALLER
#endif
#else
#ifdef OPTION_MULTITHREAD
#define VSI_CALLER SS_NAME,
#else
#define VSI_CALLER
#endif
#endif

/*
 * VERSION
 *
 * Description :  The constants define the type and the value
 *                of a version identification. The version
 *                is part of the monitor struct.
 */


#define T_VERSION   char
#define VERSION_SS  "SS 1.0"

#endif