FreeCalypso > hg > fc-magnetite
view src/gpf2/tst/idle.h @ 680:ee3ac8c617cb
armio.c: set GPIO2 output high initially
On TI-canonical platforms GPIO2 is DCD modem control output. In TI's
original code the AI_InitIOConfig() function called from Init_Target()
would configure GPIO2 as an output and set the initial output value to
low, but then the init code in uartfax.c called from Init_Serial_Flows()
would immediately change it to high, corresponding to DCD not asserted.
The result is a momentary asserted-state glitch on the DCD output.
The present change eliminates this glitch, setting DCD output to
not-asserted initially like it should be.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 25 Jun 2020 03:17:43 +0000 |
parents | cd37d228dae0 |
children |
line wrap: on
line source
/* +------------------------------------------------------------------------------ | File: idle.h +------------------------------------------------------------------------------ | Copyright Texas Instruments 2002 | All rights reserved. | +------------------------------------------------------------------------------ | Purpose: Definitions for the IDLE entity. | $Identity:$ +------------------------------------------------------------------------------ */ #ifndef IDLE_H #define IDLE_H /*==== INCLUDES ==============================================================*/ /*==== CONSTS ================================================================*/ #ifdef VSI_CALLER #undef VSI_CALLER #define VSI_CALLER idle_handle, #define VSI_CALLER_SINGLE idle_handle #endif #define hCommTST idle_hCommTST /* Communication handle to TST */ #define IDLE_REQ 0x00000010 #define IDLE_CNF 0x00010010 #ifndef __T_IDLE_CNF__ #define __T_IDLE_CNF__ typedef struct { U8 dummy; /*< 0: 1> */ } T_IDLE_CNF; #endif #ifndef __T_IDLE_REQ__ #define __T_IDLE_REQ__ typedef struct { U8 dummy; /*< 0: 1> */ } T_IDLE_REQ; #endif /*==== TYPES =================================================================*/ /*==== EXPORTS ===============================================================*/ #ifdef IDLE_PEI_C /* Communication handles */ T_HANDLE idle_handle; T_HANDLE hCommTST = VSI_ERROR; #else /* IDLE_PEI_C */ extern T_HANDLE idle_handle; extern T_HANDLE hCommTST; #endif /* IDLE_PEI_C */ #endif /* IDLE_H */ /*==== END OF FILE ===========================================================*/