FreeCalypso > hg > fc-magnetite
view cdg3/cdginc-locosto/p_t30.val @ 477:f65a4399093d
hybrid config: re-enabled obscure AT commands which require TI_PS_FF_* flags
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Thu, 14 Jun 2018 03:04:53 +0000 |
parents | c15047b3d00d |
children |
line wrap: on
line source
/* +--------------------------------------------------------------------------+ | PROJECT : PROTOCOL STACK | | FILE : p_t30.val | | SOURCE : "sap\t30.pdf" | | LastModified : "2002-04-23" | | IdAndVersion : "8411.104.98.312" | | SrcFileTime : "Thu Nov 29 09:54:28 2007" | | Generated by CCDGEN_2.5.5A on Thu Sep 25 09:18:53 2014 | | !!DO NOT MODIFY!!DO NOT MODIFY!!DO NOT MODIFY!! | +--------------------------------------------------------------------------+ */ /* PRAGMAS * PREFIX : NONE * COMPATIBILITY_DEFINES : NO (require PREFIX) * ALWAYS_ENUM_IN_VAL_FILE: NO * ENABLE_GROUP: NO * CAPITALIZE_TYPENAME: NO */ #ifndef P_T30_VAL #define P_T30_VAL #define CDG_ENTER__P_T30_VAL #define CDG_ENTER__FILENAME _P_T30_VAL #define CDG_ENTER__P_T30_VAL__FILE_TYPE CDGINC #define CDG_ENTER__P_T30_VAL__LAST_MODIFIED _2002_04_23 #define CDG_ENTER__P_T30_VAL__ID_AND_VERSION _8411_104_98_312 #define CDG_ENTER__P_T30_VAL__SRC_FILE_TIME _Thu_Nov_29_09_54_28_2007 #include "CDG_ENTER.h" #undef CDG_ENTER__P_T30_VAL #undef CDG_ENTER__FILENAME /* * Value constants for VAL_dir */ #define DIR_SND (0x0) /* send fax data */ #define DIR_RCV (0x1) /* receive fax data */ /* * Value constants for VAL_sgn */ #define SGN_OK (0x0) /* OK */ #define SGN_DIS (0x1) /* Digital identification signal */ #define SGN_CSI (0x2) /* Called subscriber identification */ #define SGN_NSF (0x4) /* Non-standard facilities */ #define SGN_CFR (0x21) /* Confirmation to receive */ #define SGN_FTT (0x22) /* Failure to train */ #define SGN_MCF (0x31) /* Message confirmation */ #define SGN_RTN (0x32) /* Retrain negative */ #define SGN_RTP (0x33) /* Retrain positive */ #define SGN_PIN (0x34) /* Procedure interrupt negative */ #define SGN_PIP (0x35) /* Procedure interrupt positive */ #define SGN_FDM (0x3f) /* File diagnostics message */ #define SGN_DCS (0x41) /* Digital command signal */ #define SGN_TSI (0x42) /* Transmitting subscriber identification */ #define SGN_SUB (0x43) /* Subaddress */ #define SGN_NSS (0x44) /* Non-standard set-up */ #define SGN_PWDR (0x45) /* Password - receive */ #define SGN_TCF (0x4f) /* Training check frame */ #define SGN_CRP (0x58) /* Command repeat */ #define SGN_DCN (0x5f) /* Disconnect */ #define SGN_EOM (0x71) /* End of message */ #define SGN_MPS (0x72) /* Multi-page signal */ #define SGN_EOP (0x74) /* End of procedure */ #define SGN_PRI_EOM (0x79) /* Procedure Interrupt - End Of Message */ #define SGN_PRI_MPS (0x7a) /* Procedure Interrupt - MultiPage Signal */ #define SGN_PRI_EOP (0x7c) /* Procedure Interrupt - End Of Procedure */ #define SGN_DTC (0x81) /* Digital transmit command */ #define SGN_CIG (0x82) /* Calling subscriber identification */ #define SGN_PWDS (0x83) /* Password - send */ #define SGN_NSC (0x84) /* Non-standard facilities command */ #define SGN_SEP (0x85) /* Selective Polling */ #define SGN_FCS_ERR (0xf1) /* FCS error */ #define SGN_NO_RES (0xf2) /* No response */ #define SGN_CONT (0xf3) /* continue */ #define SGN_NOT_USED (0xff) /* Not used */ /* * Value constants for VAL_cmpl */ #define CMPL_EOP (0x0) /* end of procedure */ #define CMPL_EOM (0x1) /* end of message */ #define CMPL_PI (0x2) /* procedure interrupt */ #define CMPL_DCN (0x3) /* disconnect */ /* * Value constants for VAL_cause */ #define ERR_PH_A_UNSPEC (0x4d10) /* unspecified phase A error */ #define ERR_PH_A_T1_TIMEOUT (0x4d11) /* no answer (T30 T1 timeout) */ #define ERR_PH_B_SND_UNSPEC (0x4d20) /* unspecified transmit phase B error */ #define ERR_PH_B_SND_CANT_RCV_OR_SND (0x4d21) /* remote cannot receive or send */ #define ERR_PH_B_SND_COMREC (0x4d22) /* COMREC error in transmit phase B */ #define ERR_PH_B_SND_COMREC_INVALID_CMD_RCVD (0x4d23)/* COMREC invalid command received */ #define ERR_PH_B_SND_RSPREC (0x4d24) /* RSPREC transmit error phase B */ #define ERR_PH_B_SND_DCS_RPTD_3_TIMES (0x4d25) /* DCS send three times without response */ #define ERR_PH_B_SND_DIS_DTC_RCVD_3_TIMES (0x4d26)/* DIS/DTC received 3 times; DCS not recognized */ #define ERR_PH_B_SND_FTT_2400 (0x4d27) /* failure to train at 2400 bit/s or +FMS value */ #define ERR_PH_B_SND_INVALID_RESP_RCVD (0x4d28) /* invalid respones received */ #define ERR_PH_C_SND_UNSPEC (0x4d40) /* unspecified transmit phase C error */ #define ERR_PH_C_SND_UNSPEC_IMAGE_CONV (0x4d41) /* unspecified image format error */ #define ERR_PH_C_SND_DTE_TO_DTC_DATA_UNDERFLOW (0x4d43)/* DTE to DTC data underflow */ #define ERR_PH_C_SND_UNRECOG_TRANSP_DATA_CMD (0x4d44)/* unrecognized transparent data command */ #define ERR_PH_C_SND_IMAGE_LINE_LENGTH (0x4d45) /* image error, line length wrong */ #define ERR_PH_C_SND_IMAGE_PAGE_LENGTH (0x4d46) /* image error, page length wrong */ #define ERR_PH_C_SND_IMAGE_COMPRESSION_MODE (0x4d47)/* image error, compression mode wrong */ #define ERR_PH_D_SND_UNSPEC (0x4d50) /* unspecified transmit phase D error */ #define ERR_PH_D_SND_RSPREC (0x4d51) /* RESPREC transmit error phase D */ #define ERR_PH_D_SND_MPS_RPTD_3_TIMES (0x4d52) /* no response to MPS repeated 3 times */ #define ERR_PH_D_SND_INVALID_RESP_TO_MPS (0x4d53) /* invalid respones to MPS */ #define ERR_PH_D_SND_EOP_RPTD_3_TIMES (0x4d54) /* no response to EOP repeated 3 times */ #define ERR_PH_D_SND_INVALID_RESP_TO_EOP (0x4d55) /* invalid response to EOP */ #define ERR_PH_D_SND_EOM_RPTD_3_TIMES (0x4d56) /* no response to EOM repeated 3 times */ #define ERR_PH_D_SND_INVALID_RESP_TO_EOM (0x4d57) /* invalid response to EOM */ #define ERR_PH_D_SND_UNABLE_TO_CONT (0x4d58) /* unable to continue after PIN or PIP */ #define ERR_PH_B_RCV_UNSPEC (0x4d70) /* unspecified receive phase B error */ #define ERR_PH_B_RCV_RSPREC (0x4d71) /* RSPREC receive error phase B */ #define ERR_PH_B_RCV_COMREC (0x4d72) /* COMREC error in receive phase B */ #define ERR_PH_B_RCV_EXP_PAGE_NOT_RCVD (0x4d73) /* T30 T2 timeout, expected page not received */ #define ERR_PH_B_RCV_T1_TIMEOUT_AFTER_EOM_RCVD (0x4d74)/* T30 T1 timeout after EOM received */ #define ERR_PH_C_RCV_UNSPEC (0x4d90) /* unspecified receive phase C error */ #define ERR_PH_C_RCV_EOL_MISSING (0x4d91) /* missing EOL after 5 seconds (3.2/T4) */ #define ERR_PH_C_RCV_DCE_TO_DTE_BUFFER_OVERFLOW (0x4d93)/* DCE to DTE buffer overflow */ #define ERR_PH_C_RCV_BAD_CRC_OR_FRAME (0x4d94) /* bad crc or frame (ECM mode) */ #define ERR_PH_D_RCV_UNSPEC (0x4da0) /* unspecified receive phase D error */ #define ERR_PH_D_RCV_RSPREC_INVALID_RESP_RCVD (0x4da1)/* RSPREC invalid respones received */ #define ERR_PH_D_RCV_COMREC_INVALID_RESP_RCVD (0x4da2)/* COMREC invalid respones received */ #define ERR_PH_D_RCV_UNABLE_TO_CONT (0x4da3) /* unable to continue after PIN or PIP */ #define ERR_PH_B_SND_RESERVED1 (0xcde0) /* reserved */ #define ERR_PH_B_SND_RESERVED2 (0xcde1) /* reserved */ #define ERR_PH_B_SND_RESERVED3 (0xcde2) /* reserved */ #define ERR_PH_C_SND_RESERVED1 (0xcde3) /* reserved */ #define ERR_PH_C_SND_RESERVED2 (0xcde4) /* reserved */ #define ERR_PH_D_SND_RESERVED1 (0xcde5) /* reserved */ #define ERR_PH_D_SND_RESERVED2 (0xcde6) /* reserved */ #define ERR_PH_D_SND_RESERVED3 (0xcde7) /* reserved */ #define ERR_PH_B_RCV_NO_RESP (0xcde8) /* T2 timeout, no response */ #define ERR_PH_B_RCV_INVALID_RESP_RCVD (0xcde9) /* invalid respones received */ #define ERR_PH_B_RCV_RESERVED3 (0xcdea) /* reserved */ #define ERR_PH_C_RCV_RESERVED1 (0xcdeb) /* reserved */ #define ERR_PH_C_RCV_RESERVED2 (0xcdec) /* reserved */ #define ERR_PH_D_RCV_NO_RESP (0xcded) /* T2 timeout, no response */ #define ERR_PH_D_RCV_INVALID_RESP_RCVD (0xcdee) /* invalid respones received */ #define ERR_PH_D_RCV_RESERVED3 (0xcdef) /* reserved */ #define ERR_SGN_NOT_ALLOWED (0xcdf0) /* signal not allowed */ #define ERR_CCD_ENC (0xcdf1) /* CCD encoding error */ /* * Value constants for VAL_test_mode */ #define TST_OFF (0x0) /* normal */ #define TST_BCS (0x1) /* test BCS formatter only */ #define TST_STUFF (0x2) /* stuffing/destuffing off */ #define TST_FCS (0x4) /* FCS generating/checking off */ #define TST_CTRL (0x8) /* Control checking off */ #define TST_RTC (0x10) /* RTC checking off */ #define TST_MIR (0x20) /* mirror report strings */ #define TST_BUF (0x80) /* show contents of buffer */ /* * Value constants for VAL_bitorder */ #define FBO_NRM_DATA (0x0) /* no change in bitorder for DATA frames */ #define FBO_NRM_STATUS (0x0) /* no change in bitorder for STATUS frames */ #define FBO_REV_DATA (0x1) /* reverse bitorder only for MSG frames */ #define FBO_REV_STATUS (0x2) /* reverse bitorder only for STATUS frames */ /* * Value constants for VAL_phase */ #define BCS_PHASE (0x0) /* Not a message phase */ #define MSG_PHASE (0x1) /* Message phase (C) */ /* * Value constants for VAL_dti_conn */ #define T30_DISCONNECT_DTI (0x0) /* Disconnect DTI from T30 */ #define T30_CONNECT_DTI (0x1) /* Connect DTI to T30 */ /* * Value constants for VAL_link_id */ #define T30_LINK_ID_DEFAULT (0x0) /* Default link id */ /* * Value constants for VAL_dti_direction */ #define T30_DTI_NORMAL (0x0) /* DTI used normally */ #define T30_DTI_INVERTED (0x1) /* DTI is inverted */ /* * user defined constants */ #define CSI_LEN (0x14) #define NSF_LEN (0x5a) #define CIG_LEN (0x14) #define NSC_LEN (0x5a) #define TSI_LEN (0x14) #define NSS_LEN (0x5a) #define PWD_LEN (0x14) #define SUB_LEN (0x14) #define SEP_LEN (0x14) #define T30_ENTITY_NAME_LEN (0x6) #include "CDG_LEAVE.h" #endif