view INSTALL @ 132:94e8a410d6bd

fc-rfcal-txcheck: pass PCL to tester (txpwr-cal-pcl)
author Mychaela Falconia <falcon@freecalypso.org>
date Mon, 20 Dec 2021 03:52:01 +0000
parents 44c6a2b4d40a
children
line wrap: on
line source

The calibration software needs to be installed on a Unix/Linux machine that is
able to communicate serially with both your CMU200 instrument and your Calypso
devices to be calibrated.  Because we use serial communication with the CMU200
instead of GPIB, no exotic drivers or libraries are needed.  However, you do
need to have FreeCalypso host tools (release fc-host-tools-r6 or later)
installed on your system under /opt/freecalypso before you can compile and
install the present calibration software, as we use the rvinterf program from
FC host tools to communicate with Calypso DUTs (or more precisely, with the
L1TM component in their firmware), and we need some rvinterf definitions in
order to compile.

Once you have fc-host-tools-r6 or later compiled and installed under
/opt/freecalypso, run 'make' to compile the calibration sw.  Then run
'make install' to add the calibration programs to your FC software installation
under /opt/freecalypso.

You will also need to create one or more cable config files corresponding to
your cabling setup(s) and place them in the /opt/freecalypso/rfcal/cableconf
directory: see doc/Cable-config-howto.