FreeCalypso > hg > fc-selenite
view src/cs/layer1/tpu_drivers/source/tpudrv.h @ 104:82ae724ca0d7
OSL reconstruction fixed to support memory supervision
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Mon, 23 Jul 2018 01:47:29 +0000 |
parents | b6a5e36de839 |
children |
line wrap: on
line source
/************* Revision Controle System Header ************* * GSM Layer 1 software * * Filename tpudrv.h * Copyright 2003 (C) Texas Instruments * ************* Revision Controle System Header *************/ /* * Device addresses - GCS000 */ // GSM 1.5 : TPU / TSP addresses //------------------------------------- #if ((CHIPSET ==2) || (CHIPSET == 3) || (CHIPSET == 4)) #define TPU_ADDR 0xFFFE0000l // Hercule / Ulysse / Samson #define TPU_RAM (TPU_ADDR + 0x1400) #define TPU_REG (TPU_ADDR + 0x1000) #define TSP_REG (TPU_ADDR + 0x0800) #define TPU_TIM (TPU_ADDR + 0x2000) #elif ((CHIPSET == 5) || (CHIPSET == 6) || (CHIPSET == 7) || (CHIPSET == 8) || (CHIPSET == 9) || (CHIPSET == 10) || (CHIPSET == 11) || (CHIPSET == 12)) #define TPU_ADDR 0xFFFF0000l // Strobe 1 address #define TPU_RAM 0xFFFF9000l // TPU RAM #define TPU_REG (TPU_ADDR + 0x1000) // TPU register #define TSP_REG 0xFFFE0800l // TSP register #define TPU_TIM 0xFFFE2000l // ULPD register #endif /* * Macros for defining TPU instructions */ #define TPU_SLEEP 0 #define TPU_MOVE(addr,data) (0x8000 | ((data)<<5) | (addr)) #define TPU_AT(time) (0x2000 | (((time + 5000) % 5000))) #define TPU_FAT(time) (0x2000 | (time)) // Fast version without modulo #define TPU_SYNC(time) (0x6000 | (time)) #define TPU_WAIT(time) (0xA000 | (time)) #define TPU_OFFSET(time) (0x4000 | (time)) #define MOD5000(a) (((a) + 5000) % 5000) /* * TSP registers - defined in GCS004 - Time Serial Port */ /* * in TPU address space */ // GSM 1.5 : TSP_TX_REG_1/2/3/4 instead of TSP_TX_U/M/L // added TSP_SPI_SET1/2/3 to ctrl up to 5 periph. //----------------------------------------------------- #define TSP_CTRL1 0x00 #define TSP_CTRL2 0x01 #define TSP_TX_REG_1 0x04 #define TSP_TX_REG_2 0x03 #define TSP_TX_REG_3 0x02 #define TSP_TX_REG_4 0x05 #define TSP_ACT 0x06 #define TSP_ACTX 0x07 #define TSP_GAUGING_EN 0x11 #define TSP_SPI_SET1 0x09 #define TSP_SPI_SET2 0x0A #define TSP_SPI_SET3 0x0B #define TPU_IT_DSP_PG 0x10 #define TSP_GAUGING_EN 0x11 /* * in ARM address space - defined in HYP004 */ #define TSP_RX_LSB (TSP_REG + 0x00) #define TSP_RX_MSB (TSP_REG + 0x02) #define TSP_TX_LSB (TSP_REG + 0x0c) #define TSP_TX_MSB (TSP_REG + 0x0a) /* * TSP registers bit definitions */ #define TC1_DEVICE0 0x00 #define TC1_DEVICE1 0x20 #define TC1_DEVICE2 0x40 #define TC1_DEVICE3 0x60 #define TC1_DEVICE4 0x80 #define TC2_RD 0x01 #define TC2_WR 0x02 #define TC2_EDGE_TRIG 0x40 #define TC2_RISING 0x80 #define TSP_CLK_RISE 0x01 #define TSP_ENA_POS 0x02 #define TSP_ENA_EDGE 0x04 #define GAUGING_START 0x01 #define GAUGING_STOP 0x00 #define TSP_ENA_POS_MSB 0x20 /* * TPU registers - defined in HYP002 */ // GSM 1.5 : TPU reg are 16-bit access //--------------------------------------- #define TPU_CTRL (TPU_REG + 0x00) #define TPU_INT_CTRL (TPU_REG + 0x02) #define TPU_INT_STAT (TPU_REG + 0x04) #define TPU_OFFSET_REG (TPU_REG + 0x0C) #define TPU_SYNCHRO_REG (TPU_REG + 0x0E) #define TPU_DSP_PG (TPU_REG + 0x20) /* * TPU control register bits */ // GSM 1.5 : TPU bits changed //--------------------------------------- #define TPU_CTRL_RESET 0x0001 #define TSP_CTRL_RESET 0x0080 #define TPU_CTRL_T_PAGE 0x0002 #define TPU_CTRL_T_ENBL 0x0004 #define TPU_CTRL_D_ENBL 0x0010 // WARNING THIS BIT DOES NOT EXIST IN HYPERION #define TPU_CTRL_SPI_RST 0x0080 #define TPU_CTRL_WAIT 0x0200 #define TPU_CTRL_CLK_EN 0x0400 #if (CHIPSET == 7) || (CHIPSET == 8) || (CHIPSET == 10) || (CHIPSET == 11) || (CHIPSET == 12) #define TPU_CTRL_FULL_WRITE 0x0800 #endif /* * TPU interrupt control register bits */ /* WARNING BUG IN HYPERION. */ /* READING TPU_INT_CRTL, TPU_INT_ITP_M BIT CONTENTS AFFECTS THE TPU_INT_ITD_M VALUE. */ #define TPU_INT_ITF_M 0x0001 #define TPU_INT_ITP_M 0x0002 #define TPU_INT_ITD_M 0x0004 #define TPU_INT_ITD_F 0x0008 // WARNING THIS BIT DOES NOT EXIST IN HYPERION #define INT_FRAME 4 /* TPU frame interrupt */ #define INT_PAGE 5 /* TPU page interrupt */ #define INT_TSP 3 /* TSP interrupt */ #if ((ANLG_FAM == 1) || (ANLG_FAM == 2) || (ANLG_FAM == 3)) // BB signals connected to serial link1 #define BULON 0x80 // bit6 #define BULCAL 0x40 // bit5 #define BULENA 0x20 // bit4 #define BDLON 0x10 // bit3 #define BDLCAL 0x08 // bit2 #define BDLENA 0x04 // bit1 #define STARTADC 0x02 // bit0 #endif /* * GSM RF programming times in quarter bits */ /**************************************************************************/ /**************************************************************************/ /****************************** W A R N I N G !!! *************************/ /******* This values are fine tuned for LAYER 1 . DO NOT MODIFY !!! *******/ /****** FOR ANY MODIFICATION , PLEASE CONTACT Texas Instruments Inc. ******/ /**************************************************************************/ /**************************************************************************/ /**************************************/ /* TPU Macros: prototypes functions */ /**************************************/ // TPU macros. //------------ void l1dmacro_reset_hw (UWORD32 servingCellOffset); void l1dmacro_init_hw (void); void l1dmacro_init_hw_light (void); void l1dmacro_idle (void); void l1dmacro_rx_synth (SYS_UWORD16 radio_freq); void l1dmacro_tx_synth (SYS_UWORD16 radio_freq); void l1dmacro_agc (SYS_UWORD16 radio_freq, WORD8 gain, UWORD8 lna); void l1dmacro_afc (SYS_UWORD16 afc_value, UWORD8 win_id); void l1dmacro_rx_ms (SYS_UWORD16 radio_freq); void l1dmacro_rx_fb (SYS_UWORD16 radio_freq); void l1dmacro_rx_fb26 (SYS_UWORD16 radio_freq); void l1dmacro_offset (UWORD32 offset_value, WORD32 relative_time); void l1dmacro_synchro (UWORD32 when, UWORD32 value); void l1dmacro_rx_sb (SYS_UWORD16 radio_freq); void l1dmacro_rx_nb (SYS_UWORD16 radio_freq); void l1dmacro_tx_nb (SYS_UWORD16 radio_freq, UWORD8 txpwr, UWORD8 adc_active); void l1dmacro_tx_ra (SYS_UWORD16 radio_freq, UWORD8 txpwr, UWORD8 adc_active); void l1dmacro_adc_read_tx (UWORD32 when); void l1dmacro_adc_read_rx (void); void l1dmacro_set_frame_it (void); void l1pdmacro_it_dsp_gen(WORD16 time); #if TESTMODE void l1dmacro_rx_cont (SYS_UWORD16 radio_freq, UWORD8 txpwr); void l1dmacro_tx_cont (SYS_UWORD16 radio_freq, UWORD8 txpwr); void l1dmacro_stop_cont (void); #endif /* * TPU prototypes */ void TP_PageIntHandler (void); void TP_FrameIntHandler (void); void TP_PageIntHandler (void); void TP_FrameIntHandler (void); void TPU_Reset(SYS_UWORD16 on); void TSP_Reset(SYS_UWORD16 on); void TPU_ClkEnable(SYS_UWORD16 on); void TP_Reset(SYS_UWORD16 on); void TP_Enable(SYS_UWORD16 on); BOOL TPU_check_IT_DSP(void); /* * TPUDRV global variables */ #ifdef TPUDRV_C #define TP_GLOBAL #else #define TP_GLOBAL extern #endif TP_GLOBAL volatile UWORD32 TP_PageInt; TP_GLOBAL volatile UWORD32 TP_FrameInt;