UI fw: load handheld audio mode on boot We have now reached the point where use of audio mode config files should be considered mandatory. In ACI usage we can tell users that they need to perform an AT@AUL of some appropriate audio mode, but in UI-enabled fw we really need to have the firmware load audio modes on its own, so that correct audio config gets established when the handset or development board runs on its own, without a connected host computer. Once have FC Venus with both main and headset audio channels and headset plug insertion detection, our fw will need to automatically load the handheld mode or the headset mode depending on the plug insertion state. For now we load only the handheld mode, which has been tuned for FC-HDS4 on FC Luna.

#ifndef _MFW_BAND_H_
#define _MFW_BAND_H_

typedef enum
{	MFW_BAND_Busy= -2,
	MFW_BAND_Fail = -1,
	MFW_BAND_OK,
	MFW_BAND_InProgress
} T_MFW_BAND_RET;

typedef enum
{
	MFW_BAND_MODE_Auto	=  0,
	MFW_BAND_MODE_Manual	=  1
} T_MFW_BAND_MODE;

/* SPR919 - SH - Band is now a bit field*/
/*a0393213 compiler warnings removal - typedef removed*/
enum
{
	MFW_BAND_GSM_900		=	1,
	MFW_BAND_DCS_1800		=	2,
	MFW_BAND_PCS_1900		=	4,
	MFW_BAND_E_GSM			=	8,
	MFW_BAND_GSM_850		=	16
};

T_MFW_BAND_RET band_radio_mode_switch(T_MFW_BAND_MODE mode, UBYTE band);

T_MFW_BAND_RET band_get_radio_modes(T_MFW_BAND_MODE* maxMode, UBYTE *band);

T_MFW_BAND_RET band_get_current_radio_mode(T_MFW_BAND_MODE* mode, UBYTE *band);
#endif /* _MFW_BAND_H_*/