view src/g23m-fad/t30/cnf_t30.h @ 280:82665effff30

keypad boot init overhaul: handle initially held-down keys This change fixes two previous behavioural defects: 1) On Compal phones, the PWR key had to be released before the boot sequence would proceed at all - it was stuck in an endless IRQ loop at the point of Nucleus enabling interrupts, before anything else. 2) On both Compal and sane platforms including Luna, if some regular non-PWR key was held down at boot time, the boot sequence would proceed and complete normally, but all non-PWR keypad buttons would be dead for the remainder of that boot cycle. The fix is a generic solution - no Compal-specific hack ended up being needed for the special case of their idiotic PWON-to-ROW4 hw wiring.
author Mychaela Falconia <falcon@freecalypso.org>
date Fri, 24 Sep 2021 00:47:12 +0000
parents fa8dc04885d8
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  GSM-F&D (8411)
|  Modul   :  CNF_T30
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Dynamic Configuration for
|             T30
+----------------------------------------------------------------------------- 
*/ 

#ifndef CNF_T30_H
#define CNF_T30_H

/*==== CONSTANTS ==================================================*/
/*
 * CONFIGURATION PARAMETER
 *
 * Description :  The constants define the commands for dynamic
 *                configuration proposals.
 */

#define  T30_TIMER_SET       "TIMER_SET"
#define  T30_TIMER_RESET     "TIMER_RESET"
#define  T30_TIMER_SPEED_UP  "TIMER_SPEED_UP"
#define  T30_TIMER_SLOW_DOWN "TIMER_SLOW_DOWN"
#define  T30_TIMER_SUPPRESS  "TIMER_SUPPRESS"

/*==== TYPES ======================================================*/

/*==== EXPORT =====================================================*/

#endif