FreeCalypso > hg > fc-tourmaline
view doc/C139-notes @ 261:841a848ba762
SPI SWE: clear any pending boot-time interrupts in spi_init()
Charger plug/unplug hw logic in the Iota ABB has no built-in debouncing,
thus electrical contact bounce on the charging power connection interface
produces a lot of charger plug/unplug interrupts. When we boot in
charging mode (charging power present at boot time and is presumably
the cause of Switch-ON), some bounce may occur between the initial
Iota Switch-ON action and Calypso firmware booting. By clearing any
accumulated ITSTATREG interrupts on boot, we prevent these pre-boot
interrupts from generating charger plug/unplug events to FCHG, which
would upset smooth from-boot charging.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Fri, 14 May 2021 02:49:05 +0000 |
parents | a62e5bf88434 |
children |
line wrap: on
line source
FC Tourmaline firmware differs from Magnetite in two principal ways when it comes to Mot C139 target support: * C139 LCD support is implemented in a more forward-looking manner: instead of emulating TI's C-Sample at the lowest R2D driver level and therefore being forever limited to 84x48 pixel display size, Tourmaline implements a new 96x64 pixel framebuffer, matching the native LCD size of C1xx phones. The UI configuration is still black&white only though - the Mother of FreeCalypso has no current plans to support color UI on smaller LCD sizes than TI's original 176x220 pix. * Our aftermarket FFS configuration has been changed from 64x3 at 0x3C0000 to 64x7 at 0x300000. Our earlier 64x3 config was chosen back in 2015, at that time we didn't know how much room we would end up needing for the firmware image vs. how much FFS content we would eventually have, and this 64x3 config is now deemed to be too small, allowing only one 64 KiB sector for FFS content. Our new FC Tourmaline aftermarket FFS config supports up to 320 KiB of FFS content, matches what we use on other platforms with 4 MiB flash chips, leaves 3 MiB for the firmware image (our current smallbw UI fw is only 2 MiB), and still avoids intersection with Motorola's (or rather Compal's) original FFS, which is important for avoiding problems in converting C139 phones back and forth between Motorola and FreeCalypso firmwares.