SPI SWE: clear any pending boot-time interrupts in spi_init() Charger plug/unplug hw logic in the Iota ABB has no built-in debouncing, thus electrical contact bounce on the charging power connection interface produces a lot of charger plug/unplug interrupts. When we boot in charging mode (charging power present at boot time and is presumably the cause of Switch-ON), some bounce may occur between the initial Iota Switch-ON action and Calypso firmware booting. By clearing any accumulated ITSTATREG interrupts on boot, we prevent these pre-boot interrupts from generating charger plug/unplug events to FCHG, which would upset smooth from-boot charging.

/*
 * BUZZER.H
 *
 * Buzzer and light control
 *
 * Target : ARM 
 *
 * Copyright (c) Texas Instruments 1996
 *
 */

#define BZ_LEVEL       ARMIO_BUZZER
#define LT_LEVEL       ARMIO_LIGHT

// Bit definitions in CNTL
#define BZ_ON			0x01	// start buzzer
#define LT_ON			0x02	// start light

// Buzzer control
void BZ_Init(void);
void BZ_Enable(void);
void BZ_Disable(void);
void BZ_Tone(int f);
void BZ_Volume(int v);
void BZ_IntHandler(void);
void BZ_KeyBeep_ON(void);
void BZ_KeyBeep_OFF(void);

// LCD and keypad Light control
void LT_Enable(void);
void LT_Disable(void);
void LT_Level(SYS_WORD8 level);
SYS_BOOL LT_Status(void);