SPI SWE: clear any pending boot-time interrupts in spi_init() Charger plug/unplug hw logic in the Iota ABB has no built-in debouncing, thus electrical contact bounce on the charging power connection interface produces a lot of charger plug/unplug interrupts. When we boot in charging mode (charging power present at boot time and is presumably the cause of Switch-ON), some bounce may occur between the initial Iota Switch-ON action and Calypso firmware booting. By clearing any accumulated ITSTATREG interrupts on boot, we prevent these pre-boot interrupts from generating charger plug/unplug events to FCHG, which would upset smooth from-boot charging.

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1AUDIO_CONST.H
 *
 *        Filename l1audio_macro.h
 *  Copyright 2003 (C) Texas Instruments  
 *
 ************* Revision Controle System Header *************/

#if (AUDIO_TASK == 1)

  /************************************************************/
  /* Macros to obtain a value put among a register            */
  /************************************************************/
  #define Field(value, mask, shift) (((value) & (mask)) >> shift)



#endif // AUDIO_TASK