SPI SWE: clear any pending boot-time interrupts in spi_init() Charger plug/unplug hw logic in the Iota ABB has no built-in debouncing, thus electrical contact bounce on the charging power connection interface produces a lot of charger plug/unplug interrupts. When we boot in charging mode (charging power present at boot time and is presumably the cause of Switch-ON), some bounce may occur between the initial Iota Switch-ON action and Calypso firmware booting. By clearing any accumulated ITSTATREG interrupts on boot, we prevent these pre-boot interrupts from generating charger plug/unplug events to FCHG, which would upset smooth from-boot charging.

/*
 * This header file defines the interface for sending messages to FCBM task.
 */

#ifndef __FCBM_SEND_MSG_H
#define __FCBM_SEND_MSG_H

#include "rv/rv_general.h"
#include "fcbm/fcbm_messages.h"

T_RV_RET fcbm_message_to_task(enum fcbm_msg_id);

#endif	/* include guard */