view src/g23m-fad/ppp/ppp_prxf.h @ 261:841a848ba762

SPI SWE: clear any pending boot-time interrupts in spi_init() Charger plug/unplug hw logic in the Iota ABB has no built-in debouncing, thus electrical contact bounce on the charging power connection interface produces a lot of charger plug/unplug interrupts. When we boot in charging mode (charging power present at boot time and is presumably the cause of Switch-ON), some bounce may occur between the initial Iota Switch-ON action and Calypso firmware booting. By clearing any accumulated ITSTATREG interrupts on boot, we prevent these pre-boot interrupts from generating charger plug/unplug events to FCHG, which would upset smooth from-boot charging.
author Mychaela Falconia <falcon@freecalypso.org>
date Fri, 14 May 2021 02:49:05 +0000
parents fa8dc04885d8
children
line wrap: on
line source

/* 
+----------------------------------------------------------------------------- 
|  Project :  
|  Modul   :  
+----------------------------------------------------------------------------- 
|  Copyright 2002 Texas Instruments Berlin, AG 
|                 All rights reserved. 
| 
|                 This file is confidential and a trade secret of Texas 
|                 Instruments Berlin, AG 
|                 The receipt of or possession of this file does not convey 
|                 any rights to reproduce or disclose its contents or to 
|                 manufacture, use, or sell anything it may describe, in 
|                 whole, or in part, without the specific written consent of 
|                 Texas Instruments Berlin, AG. 
+----------------------------------------------------------------------------- 
|  Purpose :  Definitions for ppp_prxf.c 
+----------------------------------------------------------------------------- 
*/ 

#ifndef PPP_PRXF_H
#define PPP_PRXF_H

EXTERN void prx_init (void);

#ifdef FF_STATUS_TE
EXTERN void cb_status_TE (T_DRV_SIGNAL * signal);
#endif /* FF_STATUS_TE */

#endif /* !PPP_PRXF_H */