FreeCalypso > hg > fc-tourmaline
view scripts/make-rv-swe-hdr.sh @ 268:f2e52cab0a73
abb_inth.c: check all interrupt causes, not just one
The original code used if - else if - else if etc constructs, thus
the first detected interrupt was the only one handled. However,
Iota ITSTATREG is a clear-on-read register, thus if we only handle
the first detected interrupt and skip checking the others, then the
other interrupts will be lost, if more than one interrupt happened
to occur in one ABB interrupt handling cycle - a form of rare race
condition. Change the code to check all interrupts that were read
in this cycle.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Sun, 13 Jun 2021 18:17:53 +0000 |
parents | ee04ca45053d |
children | e17bdedfbf2b |
line wrap: on
line source
#!/bin/sh echo '#ifndef __RV_SWE_H__' echo '#define __RV_SWE_H__' echo if [ "$ATP_STATE" = 1 ] then echo '#define RVM_ATP_SWE' fi echo '#define RVM_AUDIO_SWE' echo '#define RVM_ETM_SWE' echo '#define RVM_DAR_SWE' echo '#define RVM_SPI_SWE' echo '#define RVM_LLS_SWE' echo '#define RVM_KPD_SWE' if [ "$FCHG_STATE" = 1 ] then echo '#define RVM_FCHG_SWE' fi if [ "$LCC_STATE" = 1 ] then echo '#define RVM_LCC_SWE' fi if [ "$PWR_STATE" = 1 ] then echo '#define RVM_PWR_SWE' fi if [ "$R2D_STATE" = 1 ] then echo '#define RVM_R2D_SWE' fi if [ "$MKS_STATE" = 1 ] then echo '#define RVM_MKS_SWE' fi echo '#define RVM_RTC_SWE' echo '#define RVM_FFS_SWE' if [ "$FCBM_STATE" = 1 ] then echo '#define RVM_FCBM_SWE' fi echo echo '#endif /* __RV_SWE_H__ */'