!GPRS config: fix long-standing AT+COPS chance hanging bug There has been a long-standing bug in FreeCalypso going back years: sometimes in the AT command bring-up sequence of an ACI-only MS, the AT+COPS command would produce only a power scan followed by cessation of protocol stack activity (only L1 ADC traces), instead of the expected network search sequence. This behaviour was seen in different FC firmware versions going back to Citrine, and seemed to follow some law of chance, not reliably repeatable. This bug has been tracked down and found to be specific to !GPRS configuration, stemming from our TCS2/TCS3 hybrid and reconstruction of !GPRS support that was bitrotten in TCS3.2/LoCosto version. ACI module psa_mms.c, needed only for !GPRS, was missing in the TCS3 version and had to be pulled from TCS2 - but as it turns out, there is a new field in the MMR_REG_REQ primitive that needs to be set correctly, and that psa_mms.c module is the place where this initialization needed to be added.

[board.cfg]

BOARD 41

[chipset.cfg]

ANLG_FAM 2
ANLG_PG 0
CHIPSET var

[debug.cfg]

TI_NUC_MONITOR 0
TI_PROFILER var

[dio.cfg]

DIOIL_CONFIG 0

[ffs.cfg]

TARGET 1
_RVF 1

[l1sw.cfg]

AMR var
CUST 0
DCO_ALGO 0
IDS var
L1_12NEIGH 1
L1_EOTD 0
L1_EOTD_QBIT_ACC 0
L1_GPRS var
L1_GTT 0
L1_MIDI 0
L1_VOICE_MEMO_AMR var
MELODY_E2 var
OP_L1_STANDALONE 0
OP_RIV_AUDIO 1
ORDER2_TX_TEMP_CAL 1
RAZ_VULSWITCH_REGAUDIO 0
SECURITY 0
SPEECH_RECO var
TESTMODE 1
TRACE_TYPE 4
VCXO_ALGO 1

[r2d.cfg]

R2D_ASM 0
R2D_EMBEDDED_LCD var
R2D_LCD_TEST 0

[rf.cfg]

RF var
RF_FAM var
RF_PA var
RF_PG var

[rv.cfg]

RVTOOL 0
TEST 0
_GSM 1

[swconfig.cfg]

ALR 1
BT 0
DP 0
DWNLD 1
GSMLITE 0
L1_DYN_DSP_DWNLD var
LONG_JUMP 3
MOVE_IN_INTERNAL_RAM 1
OP_WCP 0
PMODE var
RVDATA_INTERNALRAM 0
SRVC var
TR_BAUD_CONFIG var
WCP_PROF 0

[sys.cfg]

DSP var
STD 6

[trace.cfg]

LAYER_DBG 0xFFFFFFFF
TRACE_LEVEL_FILTER 5