!GPRS config: fix long-standing AT+COPS chance hanging bug There has been a long-standing bug in FreeCalypso going back years: sometimes in the AT command bring-up sequence of an ACI-only MS, the AT+COPS command would produce only a power scan followed by cessation of protocol stack activity (only L1 ADC traces), instead of the expected network search sequence. This behaviour was seen in different FC firmware versions going back to Citrine, and seemed to follow some law of chance, not reliably repeatable. This bug has been tracked down and found to be specific to !GPRS configuration, stemming from our TCS2/TCS3 hybrid and reconstruction of !GPRS support that was bitrotten in TCS3.2/LoCosto version. ACI module psa_mms.c, needed only for !GPRS, was missing in the TCS3 version and had to be pulled from TCS2 - but as it turns out, there is a new field in the MMR_REG_REQ primitive that needs to be set correctly, and that psa_mms.c module is the place where this initialization needed to be added.

#!/bin/sh

echo '#ifndef __RV_SWE_H__'
echo '#define __RV_SWE_H__'
echo

if [ "$ATP_STATE" = 1 ]
then
	echo '#define RVM_ATP_SWE'
fi

echo '#define RVM_AUDIO_SWE'
echo '#define RVM_ETM_SWE'
echo '#define RVM_DAR_SWE'
echo '#define RVM_SPI_SWE'
echo '#define RVM_LLS_SWE'
echo '#define RVM_KPD_SWE'

if [ "$FCHG_STATE" = 1 ]
then
	echo '#define RVM_FCHG_SWE'
fi

if [ "$LCC_STATE" = 1 ]
then
	echo '#define RVM_LCC_SWE'
fi

if [ "$PWR_STATE" = 1 ]
then
	echo '#define RVM_PWR_SWE'
fi

if [ "$R2D_STATE" = 1 ]
then
	echo '#define RVM_R2D_SWE'
fi

if [ "$MKS_STATE" = 1 ]
then
	echo '#define RVM_MKS_SWE'
fi

echo '#define RVM_RTC_SWE'
echo '#define RVM_FFS_SWE'

if [ "$BUZM_STATE" = 1 ]
then
	echo '#define RVM_BUZM_SWE'
fi

if [ "$VIBR_STATE" = 1 ]
then
	echo '#define RVM_VIBR_SWE'
fi

if [ "$FCBM_STATE" = 1 ]
then
	echo '#define RVM_FCBM_SWE'
fi

echo
echo '#endif /* __RV_SWE_H__ */'