--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/doc/Shipped-EEPROM-configs	Sun Sep 10 05:19:50 2023 +0000
@@ -0,0 +1,52 @@
+There are a number of ready-made FTDI EEPROM config files shipped with
+fc-usbser-tools package, intended to serve as inputs to ftee-gen* tools.  This
+article describes these shipped EEPROM configs.
+
+duart28c and duart28s
+=====================
+
+FreeCalypso DUART28 is an FT2232D-based custom hardware adapter produced in
+year 2020.  There are two valid EEPROM configs for this adapter, named DUART28C
+and DUART28S - see DUART28-EEPROM-config article for further details.
+
+ft2232-example
+==============
+
+This config file is an example EEPROM config for FT2232x chips, valid for both
+FT2232C/D and FT2232H.  It is intended to serve as a starting point for custom
+FT2232x EEPROM configurations.
+
+ft232r-example
+==============
+
+This config file is an example EEPROM config for FT232R.  It is intended to
+serve as a starting point for custom FT232R EEPROM configs.
+
+icestick
+========
+
+Lattice iCEstick is a handy FPGA board with an FT2232H USB interface chip,
+supporting SPI programming via MPSSE on Channel A and UART communication with
+user logic via FT2232H Channel B.  However, instead of programming this FT2232H
+chip's EEPROM with a distinctive USB VID:PID which Linux kernel ftdi_sio driver
+can recognize as a JTAG quirk, Lattice ships these boards with blank EEPROMs,
+causing the usual well-known problems with unquirked ftdi_sio binding.
+
+Our supplied EEPROM config named "icestick" is intended as the solution:
+program it into the EEPROM on your iCEstick board, and the binding of ftdi_sio
+driver becomes sensible, with a ttyUSB device created only for Channel B.
+
+jtag-unbuf
+==========
+
+This EEPROM config is meant for generic (non-specialized) FT2232D breakout
+boards used as unbuffered JTAG adapters, as described in this old guide
+from 2019:
+
+https://www.freecalypso.org/hg/freecalypso-hwlab/file/tip/doc/Unbuffered-FT2232x-JTAG
+
+mcu-host-bus
+============
+
+This EEPROM config is meant for the same generic FT2232D breakout boards used
+in MCU host bus emulation mode, which takes up both channels and leaves no UART.