--- a/FCDEV3B-repackaging	Wed Oct 10 07:28:15 2018 +0000
+++ b/FCDEV3B-repackaging	Wed Oct 10 16:33:11 2018 +0000
@@ -86,7 +86,7 @@
   FreeCalypso GPIO 1 is taken because we use it for the loudspeaker control
   signal like on TI's D-Sample and Leonardo boards, hence we are moving the AP
   wakeup signal to GPIO 0, to be implemented if and when anyone builds a modem
-  based on FC-TMS that needs to be provide such a signal.
+  based on FC-TMS that needs to provide such a signal.
 
 * If your product includes a loudspeaker amplifier like on our FCDEV3B, connect
   its on/off control input to GPIO 1, otherwise leave our GPIO 1 output
@@ -106,7 +106,8 @@
   DSR and RI to TSPDI/IO4 and MCUEN1/IO8, respectively.  Right now our fw
   drives IO4 low and IO8 high, corresponding to DSR asserted and RI negated
   (normal quiescent state), and connecting the signals in this way allows the
-  possibility of extending the fw to drive them in some more intelligent manner.
+  possibility of extending the fw to drive them in some more intelligent manner
+  if need be.
 
 * Both Calypso UARTs need to be wired in an accessible way so that our standard
   FC Magnetite firmware can be used with the AT command interface on the MODEM