# HG changeset patch # User Mychaela Falconia # Date 1539189191 0 # Node ID 4f873ec004f69d86cff3c8ed0daf4faa2e66da23 # Parent 020df28341d0b1e216bad8f92523a94bf83d7bf2 FCDEV3B-repackaging: minor grammar fixes diff -r 020df28341d0 -r 4f873ec004f6 FCDEV3B-repackaging --- a/FCDEV3B-repackaging Wed Oct 10 07:28:15 2018 +0000 +++ b/FCDEV3B-repackaging Wed Oct 10 16:33:11 2018 +0000 @@ -86,7 +86,7 @@ FreeCalypso GPIO 1 is taken because we use it for the loudspeaker control signal like on TI's D-Sample and Leonardo boards, hence we are moving the AP wakeup signal to GPIO 0, to be implemented if and when anyone builds a modem - based on FC-TMS that needs to be provide such a signal. + based on FC-TMS that needs to provide such a signal. * If your product includes a loudspeaker amplifier like on our FCDEV3B, connect its on/off control input to GPIO 1, otherwise leave our GPIO 1 output @@ -106,7 +106,8 @@ DSR and RI to TSPDI/IO4 and MCUEN1/IO8, respectively. Right now our fw drives IO4 low and IO8 high, corresponding to DSR asserted and RI negated (normal quiescent state), and connecting the signals in this way allows the - possibility of extending the fw to drive them in some more intelligent manner. + possibility of extending the fw to drive them in some more intelligent manner + if need be. * Both Calypso UARTs need to be wired in an accessible way so that our standard FC Magnetite firmware can be used with the AT command interface on the MODEM