--- a/venus/doc/Charging-circuit	Sun Dec 05 03:38:33 2021 +0000
+++ b/venus/doc/Charging-circuit	Sun Dec 05 03:49:14 2021 +0000
@@ -34,15 +34,15 @@
 will have 4 terminals rather than 2, with terminal numbers assigned as follows:
 
 Pin 1 = resistor side 1, surface layer
-Pin 2 = resistor side 1, inner layer
-Pin 3 = resistor side 2, surface layer
+Pin 2 = resistor side 2, surface layer
+Pin 3 = resistor side 1, inner layer
 Pin 4 = resistor side 2, inner layer
 
 The idea is to include in-pad microvias going one layer down inside the
-subcircuit, and put terminals 2 and 4 on the inner layer.  Terminals 1 & 2 will
-form one intnoconn group, and terminals 3 & 4 will form the other intnoconn
+subcircuit, and put terminals 3 and 4 on the inner layer.  Terminals 1 & 3 will
+form one intnoconn group, and terminals 2 & 4 will form the other intnoconn
 group.  Surface traces carrying the charging current will connect to terminals
-1 and 3, whereas sensing nets VCCS and VBATS will connect to terminals 2 and 4
+1 and 2, whereas sensing nets VCCS and VBATS will connect to terminals 3 and 4
 on the inner layer.
 
 Our current ueda source implements this idea at the netlist level; creation of