manual RESET button new part: 260 g force, shorter actuator One of the main envisioned use cases for FC Venus is field demonstration: the board will be carried around, mounted on a sheet of acrylic or somesuch, it will have a battery and an antenna connected, there will be a test SIM with active service inserted, and the setup will be ready to demonstrate as a working phone at a moment's notice. But when a demo is not actively in progress, the fully assembled setup will be transported around in a big and loose ESD bag, and it will need to be equivalent to a traditional phone in its switched-off state: battery present, RTC keeping time, but not switched on all the time. Having a RESET button of the same keyswitch type as used for the regular keypad and PWON would cause a problem for such field transport scenarios: any spurious press of this button would cause a "misc boot" switch-on. Short spurious presses of PWON are filtered out by the firmware (automatic power-off if the button isn't held down long enough), but the same cannot be done for super-low-level nTESTRESET. However, a button with significantly greater operating force and a shorter actuator (not sticking out to the same height as the regular keypad buttons) should be much safer.

/* RF Tx path from Rita to PA, low bands */

module rfmatch_rita2pa_lb (In, Out, GND);

input In;
output Out;
input GND;

wire mid1, mid2;

inductor L601 (In, mid1);
capacitor C655 (mid1, mid2);
chip_attenuator R600 (mid2, Out, GND, GND);

endmodule